@@ -142,9 +142,6 @@ extern int ioapic_dynirq_base;
struct io_apic_irq_attr;
struct irq_cfg;
-extern int io_apic_set_pci_routing(struct device *dev, int irq,
- struct io_apic_irq_attr *irq_attr);
-extern void setup_IO_APIC_irq_extra(u32 gsi);
extern void ioapic_insert_resources(void);
extern int native_setup_ioapic_entry(int, struct IO_APIC_route_entry *,
@@ -156,8 +153,6 @@ extern void native_compose_msi_msg(struct pci_dev *pdev,
unsigned int irq, unsigned int dest,
struct msi_msg *msg, u8 hpet_id);
extern void native_eoi_ioapic_pin(int apic, int pin, int vector);
-extern int io_apic_setup_irq_pin_once(unsigned int irq, int node,
- struct io_apic_irq_attr *attr);
extern int save_ioapic_entries(void);
extern void mask_ioapic_entries(void);
@@ -231,10 +226,6 @@ static inline int mp_map_pin_to_irq(int idx, int ioapic, int pin, int alloc)
return -1;
}
-struct io_apic_irq_attr;
-static inline int io_apic_set_pci_routing(struct device *dev, int irq,
- struct io_apic_irq_attr *irq_attr) { return 0; }
-
static inline int save_ioapic_entries(void)
{
return -ENOMEM;
@@ -111,7 +111,6 @@ static struct ioapic {
struct irq_domain *irqdomain;
ioapic_create_domain_fn irqdomain_cb;
void *irqdomain_arg;
- DECLARE_BITMAP(pin_programmed, MP_MAX_IOAPIC_PIN + 1);
} ioapics[MAX_IO_APICS];
#define mpc_ioapic_ver(ioapic_idx) ioapics[ioapic_idx].mp_config.apicver
@@ -209,9 +208,6 @@ static int __init parse_noapic(char *str)
}
early_param("noapic", parse_noapic);
-static int io_apic_setup_irq_pin(unsigned int irq, int node,
- struct io_apic_irq_attr *attr);
-
/* Will be called in mpparse/acpi/sfi codes for saving IRQ info */
void mp_save_irq(struct mpc_intsrc *m)
{
@@ -1082,9 +1078,6 @@ int mp_map_pin_to_irq(int idx, int ioapic, int pin, int alloc)
static int pin_2_irq(int idx, int apic, int pin, int alloc)
{
- int irq;
- int bus = mp_irqs[idx].srcbus;
-
/*
* Debugging check, we are in big trouble if this message pops up!
*/
@@ -1096,6 +1089,8 @@ static int pin_2_irq(int idx, int apic, int pin, int alloc)
* PCI IRQ command line redirection. Yes, limits are hardcoded.
*/
if ((pin >= 16) && (pin <= 23)) {
+ int irq;
+
if (pirq_entries[pin-16] != -1) {
if (!pirq_entries[pin-16]) {
apic_printk(APIC_VERBOSE, KERN_DEBUG
@@ -1111,12 +1106,7 @@ static int pin_2_irq(int idx, int apic, int pin, int alloc)
}
#endif
- if (test_bit(bus, mp_bus_not_pci))
- irq = mp_irqs[idx].srcbusirq;
- else
- irq = mp_map_pin_to_irq(idx, apic, pin, alloc);
-
- return irq;
+ return mp_map_pin_to_irq(idx, apic, pin, alloc);
}
/*
@@ -1482,90 +1472,24 @@ static void setup_ioapic_irq(unsigned int irq, struct irq_cfg *cfg,
ioapic_write_entry(attr->ioapic, attr->ioapic_pin, entry);
}
-static bool __init io_apic_pin_not_connected(int idx, int ioapic_idx, int pin)
-{
- if (idx != -1)
- return false;
-
- apic_printk(APIC_VERBOSE, KERN_DEBUG " apic %d pin %d not connected\n",
- mpc_ioapic_id(ioapic_idx), pin);
- return true;
-}
-
-static void __init __io_apic_setup_irqs(unsigned int ioapic_idx)
-{
- int idx, node = cpu_to_node(0);
- struct io_apic_irq_attr attr;
- unsigned int pin, irq;
-
- for_each_pin(ioapic_idx, pin) {
- if (!mp_init_pin_at_boot(ioapic_idx, pin))
- continue;
-
- idx = find_irq_entry(ioapic_idx, pin, mp_INT);
- if (io_apic_pin_not_connected(idx, ioapic_idx, pin))
- continue;
-
- irq = pin_2_irq(idx, ioapic_idx, pin, 1);
- if (irq < 0)
- continue;
-
- /*
- * Skip the timer IRQ if there's a quirk handler
- * installed and if it returns 1:
- */
- if (apic->multi_timer_check &&
- apic->multi_timer_check(ioapic_idx, irq))
- continue;
-
- set_io_apic_irq_attr(&attr, ioapic_idx, pin, irq_trigger(idx),
- irq_polarity(idx));
-
- io_apic_setup_irq_pin(irq, node, &attr);
- }
-}
-
static void __init setup_IO_APIC_irqs(void)
{
- unsigned int ioapic_idx;
+ int idx;
+ unsigned int ioapic, pin;
apic_printk(APIC_VERBOSE, KERN_DEBUG "init IO_APIC IRQs\n");
- for_each_ioapic(ioapic_idx)
- __io_apic_setup_irqs(ioapic_idx);
-}
-
-/*
- * for the gsi that is not in first ioapic
- * but could not use acpi_register_gsi()
- * like some special sci in IBM x3330
- */
-void setup_IO_APIC_irq_extra(u32 gsi)
-{
- int ioapic_idx = 0, pin, idx, irq, node = cpu_to_node(0);
- struct io_apic_irq_attr attr;
-
- /*
- * Convert 'gsi' to 'ioapic.pin'.
- */
- ioapic_idx = mp_find_ioapic(gsi);
- if (ioapic_idx < 0)
- return;
-
- pin = mp_find_ioapic_pin(ioapic_idx, gsi);
- if (mp_init_pin_at_boot(ioapic_idx, pin))
- return;
-
- idx = find_irq_entry(ioapic_idx, pin, mp_INT);
- if (idx == -1)
- return;
-
- irq = pin_2_irq(idx, ioapic_idx, pin, 1);
-
- set_io_apic_irq_attr(&attr, ioapic_idx, pin, irq_trigger(idx),
- irq_polarity(idx));
+ for_each_ioapic_pin(ioapic, pin) {
+ if (!mp_init_pin_at_boot(ioapic, pin))
+ continue;
- io_apic_setup_irq_pin_once(irq, node, &attr);
+ idx = find_irq_entry(ioapic, pin, mp_INT);
+ if (idx < 0)
+ apic_printk(APIC_VERBOSE, KERN_DEBUG " apic %d pin %d not connected\n",
+ mpc_ioapic_id(ioapic), pin);
+ else
+ pin_2_irq(idx, ioapic, pin, 1);
+ }
}
/*
@@ -3512,27 +3436,6 @@ io_apic_setup_irq_pin(unsigned int irq, int node, struct io_apic_irq_attr *attr)
return ret;
}
-int io_apic_setup_irq_pin_once(unsigned int irq, int node,
- struct io_apic_irq_attr *attr)
-{
- unsigned int ioapic_idx = attr->ioapic, pin = attr->ioapic_pin;
- int ret;
- struct IO_APIC_route_entry orig_entry;
-
- /* Avoid redundant programming */
- if (test_bit(pin, ioapics[ioapic_idx].pin_programmed)) {
- pr_debug("Pin %d-%d already programmed\n", mpc_ioapic_id(ioapic_idx), pin);
- orig_entry = ioapic_read_entry(attr->ioapic, pin);
- if (attr->trigger == orig_entry.trigger && attr->polarity == orig_entry.polarity)
- return 0;
- return -EBUSY;
- }
- ret = io_apic_setup_irq_pin(irq, node, attr);
- if (!ret)
- set_bit(pin, ioapics[ioapic_idx].pin_programmed);
- return ret;
-}
-
static int __init io_apic_get_redir_entries(int ioapic)
{
union IO_APIC_reg_01 reg_01;
@@ -3579,22 +3482,6 @@ int __init arch_probe_nr_irqs(void)
return NR_IRQS_LEGACY;
}
-int io_apic_set_pci_routing(struct device *dev, int irq,
- struct io_apic_irq_attr *irq_attr)
-{
- int node;
-
- if (!IO_APIC_IRQ(irq)) {
- apic_printk(APIC_QUIET,KERN_ERR "IOAPIC[%d]: Invalid reference to IRQ 0\n",
- irq_attr->ioapic);
- return -EINVAL;
- }
-
- node = dev ? dev_to_node(dev) : cpu_to_node(0);
-
- return io_apic_setup_irq_pin_once(irq, node, irq_attr);
-}
-
#ifdef CONFIG_X86_32
static int __init io_apic_get_unique_id(int ioapic, int apic_id)
{
@@ -4015,7 +3902,7 @@ int mp_irqdomain_map(struct irq_domain *domain, unsigned int virq,
* returns 1:
*/
if (apic->multi_timer_check &&
- apic->multi_timer_check(ioapic, hwirq))
+ apic->multi_timer_check(ioapic, virq))
return 0;
/* Get default attribute if not set by caller yet */
Now we have converted all x86 platforms to use the common irqdomain map interface, and there are only two callers of io_apic_setup_irq_pin(): mp_irqdomain_map() and pre_init_apic_IRQ0(). There's no caller of io_apic_set_pci_routing(), setup_IO_APIC_irq_extra() and io_apic_setup_irq_pin_once(), so kill them. Signed-off-by: Jiang Liu <jiang.liu@linux.intel.com> --- arch/x86/include/asm/io_apic.h | 9 --- arch/x86/kernel/apic/io_apic.c | 145 +++++----------------------------------- 2 files changed, 16 insertions(+), 138 deletions(-)