@@ -18,6 +18,7 @@
#include <linux/hwmon.h>
#include <linux/gfp.h>
#include <linux/spinlock.h>
+#include <linux/pci.h>
#define HWMON_ID_PREFIX "hwmon"
#define HWMON_ID_FORMAT HWMON_ID_PREFIX "%d"
@@ -86,8 +87,36 @@ void hwmon_device_unregister(struct devi
"hwmon_device_unregister() failed: bad class ID!\n");
}
+static void __init hwmon_pci_quirks(void)
+{
+#if defined CONFIG_X86 && defined CONFIG_PCI
+ struct pci_dev *sb;
+ u16 base;
+ u8 enable;
+
+ /* Open access to 0x295-0x296 on MSI MS-7031 */
+ sb = pci_get_device(PCI_VENDOR_ID_ATI, 0x436c, NULL);
+ if (sb &&
+ (sb->subsystem_vendor == 0x1462 && /* MSI */
+ sb->subsystem_device == 0x0031)) { /* MS-7031 */
+
+ pci_read_config_byte(sb, 0x48, &enable);
+ pci_read_config_word(sb, 0x64, &base);
+
+ if (base == 0 && !(enable & BIT(2))) {
+ dev_info(&sb->dev,
+ "Opening wide generic port at 0x295\n");
+ pci_write_config_word(sb, 0x64, 0x295);
+ pci_write_config_byte(sb, 0x48, enable | BIT(2));
+ }
+ }
+#endif
+}
+
static int __init hwmon_init(void)
{
+ hwmon_pci_quirks();
+
hwmon_class = class_create(THIS_MODULE, "hwmon");
if (IS_ERR(hwmon_class)) {
printk(KERN_ERR "hwmon.c: couldn't create sysfs class\n");
The MSI MS-7031 is based on an ATI IXP300 south bridge. On this south bridge, accessible I/O ports must be enabled explicitly. Unfortunately the BIOS forgets to enable access to the hardware monitoring chip I/O ports, so hardware monitoring fails. Add a quirk enabling access to the required ports (0x295-0x296). This is exactly what MSI's own hardware monitoring application is doing, so it has to be the right way. Signed-off-by: Jean Delvare <khali@linux-fr.org> --- drivers/hwmon/hwmon.c | 29 +++++++++++++++++++++++++++++ 1 file changed, 29 insertions(+)