diff mbox

[v4,6/6] PCI: rcar: Shut the PHY down in failpath

Message ID 20180524143624.26718-7-marek.vasut+renesas@gmail.com (mailing list archive)
State New, archived
Delegated to: Bjorn Helgaas
Headers show

Commit Message

Marek Vasut May 24, 2018, 2:36 p.m. UTC
If anything fails past phy_init_fn() and the system is a Gen3 with
a PHY, the PHY will be left on and inited. This is caused by the
phy_init_fn, which is in fact a pointer to rcar_pcie_phy_init_gen3()
function, which starts the PHY, yet has no counterpart in the failpath.
Add that counterpart.

Signed-off-by: Marek Vasut <marek.vasut+renesas@gmail.com>
Cc: Geert Uytterhoeven <geert+renesas@glider.be>
Cc: Lorenzo Pieralisi <lorenzo.pieralisi@arm.com>
Cc: Phil Edworthy <phil.edworthy@renesas.com>
Cc: Simon Horman <horms+renesas@verge.net.au>
Cc: Wolfram Sang <wsa@the-dreams.de>
Cc: linux-renesas-soc@vger.kernel.org
Fixes: 517ca93a7159 ("PCI: rcar: Add R-Car gen3 PHY support")
---
V4: New patch
---
 drivers/pci/host/pcie-rcar.c | 10 ++++++++--
 1 file changed, 8 insertions(+), 2 deletions(-)

Comments

Geert Uytterhoeven May 25, 2018, 10:09 a.m. UTC | #1
On Thu, May 24, 2018 at 4:36 PM, Marek Vasut <marek.vasut@gmail.com> wrote:
> If anything fails past phy_init_fn() and the system is a Gen3 with
> a PHY, the PHY will be left on and inited. This is caused by the
> phy_init_fn, which is in fact a pointer to rcar_pcie_phy_init_gen3()
> function, which starts the PHY, yet has no counterpart in the failpath.
> Add that counterpart.
>
> Signed-off-by: Marek Vasut <marek.vasut+renesas@gmail.com>

Reviewed-by: Geert Uytterhoeven <geert+renesas@glider.be>

Note that there's another unhandled failure mode: rcar_pcie_phy_init_gen3()
doesn't call phy_exit() if phy_power_on() fails.

Gr{oetje,eeting}s,

                        Geert
Marek Vasut May 25, 2018, 6:34 p.m. UTC | #2
On 05/25/2018 12:09 PM, Geert Uytterhoeven wrote:
> On Thu, May 24, 2018 at 4:36 PM, Marek Vasut <marek.vasut@gmail.com> wrote:
>> If anything fails past phy_init_fn() and the system is a Gen3 with
>> a PHY, the PHY will be left on and inited. This is caused by the
>> phy_init_fn, which is in fact a pointer to rcar_pcie_phy_init_gen3()
>> function, which starts the PHY, yet has no counterpart in the failpath.
>> Add that counterpart.
>>
>> Signed-off-by: Marek Vasut <marek.vasut+renesas@gmail.com>
> 
> Reviewed-by: Geert Uytterhoeven <geert+renesas@glider.be>
> 
> Note that there's another unhandled failure mode: rcar_pcie_phy_init_gen3()
> doesn't call phy_exit() if phy_power_on() fails.

Should be fixed by subsequent patch, thanks.
Simon Horman May 28, 2018, 8:48 a.m. UTC | #3
On Thu, May 24, 2018 at 04:36:24PM +0200, Marek Vasut wrote:
> If anything fails past phy_init_fn() and the system is a Gen3 with
> a PHY, the PHY will be left on and inited. This is caused by the
> phy_init_fn, which is in fact a pointer to rcar_pcie_phy_init_gen3()
> function, which starts the PHY, yet has no counterpart in the failpath.
> Add that counterpart.
> 
> Signed-off-by: Marek Vasut <marek.vasut+renesas@gmail.com>
> Cc: Geert Uytterhoeven <geert+renesas@glider.be>
> Cc: Lorenzo Pieralisi <lorenzo.pieralisi@arm.com>
> Cc: Phil Edworthy <phil.edworthy@renesas.com>
> Cc: Simon Horman <horms+renesas@verge.net.au>
> Cc: Wolfram Sang <wsa@the-dreams.de>
> Cc: linux-renesas-soc@vger.kernel.org
> Fixes: 517ca93a7159 ("PCI: rcar: Add R-Car gen3 PHY support")

Acked-by: Simon Horman <horms+renesas@verge.net.au>

> ---
> V4: New patch
> ---
>  drivers/pci/host/pcie-rcar.c | 10 ++++++++--
>  1 file changed, 8 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/pci/host/pcie-rcar.c b/drivers/pci/host/pcie-rcar.c
> index 636c3c5095d2..695781934f0a 100644
> --- a/drivers/pci/host/pcie-rcar.c
> +++ b/drivers/pci/host/pcie-rcar.c
> @@ -1163,7 +1163,7 @@ static int rcar_pcie_probe(struct platform_device *pdev)
>  	if (rcar_pcie_hw_init(pcie)) {
>  		dev_info(dev, "PCIe link down\n");
>  		err = -ENODEV;
> -		goto err_clk_disable;
> +		goto err_phy_shutdown;
>  	}
>  
>  	data = rcar_pci_read_reg(pcie, MACSR);
> @@ -1175,7 +1175,7 @@ static int rcar_pcie_probe(struct platform_device *pdev)
>  			dev_err(dev,
>  				"failed to enable MSI support: %d\n",
>  				err);
> -			goto err_clk_disable;
> +			goto err_phy_shutdown;
>  		}
>  	}
>  
> @@ -1189,6 +1189,12 @@ static int rcar_pcie_probe(struct platform_device *pdev)
>  	if (IS_ENABLED(CONFIG_PCI_MSI))
>  		rcar_pcie_teardown_msi(pcie);
>  
> +err_phy_shutdown:
> +	if (pcie->phy) {
> +		phy_power_off(pcie->phy);
> +		phy_exit(pcie->phy);
> +	}
> +
>  err_clk_disable:
>  	clk_disable_unprepare(pcie->bus_clk);
>  
> -- 
> 2.16.2
>
Marek Vasut June 1, 2018, 11:30 p.m. UTC | #4
On 05/28/2018 10:48 AM, Simon Horman wrote:
> On Thu, May 24, 2018 at 04:36:24PM +0200, Marek Vasut wrote:
>> If anything fails past phy_init_fn() and the system is a Gen3 with
>> a PHY, the PHY will be left on and inited. This is caused by the
>> phy_init_fn, which is in fact a pointer to rcar_pcie_phy_init_gen3()
>> function, which starts the PHY, yet has no counterpart in the failpath.
>> Add that counterpart.
>>
>> Signed-off-by: Marek Vasut <marek.vasut+renesas@gmail.com>
>> Cc: Geert Uytterhoeven <geert+renesas@glider.be>
>> Cc: Lorenzo Pieralisi <lorenzo.pieralisi@arm.com>
>> Cc: Phil Edworthy <phil.edworthy@renesas.com>
>> Cc: Simon Horman <horms+renesas@verge.net.au>
>> Cc: Wolfram Sang <wsa@the-dreams.de>
>> Cc: linux-renesas-soc@vger.kernel.org
>> Fixes: 517ca93a7159 ("PCI: rcar: Add R-Car gen3 PHY support")
> 
> Acked-by: Simon Horman <horms+renesas@verge.net.au>

While I see the first 5 in today's next, I don't see this one there, so
it'd be nice to add it too.
Lorenzo Pieralisi June 29, 2018, 1:38 p.m. UTC | #5
On Thu, May 24, 2018 at 04:36:24PM +0200, Marek Vasut wrote:
> If anything fails past phy_init_fn() and the system is a Gen3 with
> a PHY, the PHY will be left on and inited. This is caused by the
> phy_init_fn, which is in fact a pointer to rcar_pcie_phy_init_gen3()
> function, which starts the PHY, yet has no counterpart in the failpath.
> Add that counterpart.
> 
> Signed-off-by: Marek Vasut <marek.vasut+renesas@gmail.com>
> Cc: Geert Uytterhoeven <geert+renesas@glider.be>
> Cc: Lorenzo Pieralisi <lorenzo.pieralisi@arm.com>
> Cc: Phil Edworthy <phil.edworthy@renesas.com>
> Cc: Simon Horman <horms+renesas@verge.net.au>
> Cc: Wolfram Sang <wsa@the-dreams.de>
> Cc: linux-renesas-soc@vger.kernel.org
> Fixes: 517ca93a7159 ("PCI: rcar: Add R-Car gen3 PHY support")
> ---
> V4: New patch
> ---
>  drivers/pci/host/pcie-rcar.c | 10 ++++++++--
>  1 file changed, 8 insertions(+), 2 deletions(-)

Applied to pci/controller-fixes to be tentatively merged at -rc4,
thanks.

Lorenzo

> diff --git a/drivers/pci/host/pcie-rcar.c b/drivers/pci/host/pcie-rcar.c
> index 636c3c5095d2..695781934f0a 100644
> --- a/drivers/pci/host/pcie-rcar.c
> +++ b/drivers/pci/host/pcie-rcar.c
> @@ -1163,7 +1163,7 @@ static int rcar_pcie_probe(struct platform_device *pdev)
>  	if (rcar_pcie_hw_init(pcie)) {
>  		dev_info(dev, "PCIe link down\n");
>  		err = -ENODEV;
> -		goto err_clk_disable;
> +		goto err_phy_shutdown;
>  	}
>  
>  	data = rcar_pci_read_reg(pcie, MACSR);
> @@ -1175,7 +1175,7 @@ static int rcar_pcie_probe(struct platform_device *pdev)
>  			dev_err(dev,
>  				"failed to enable MSI support: %d\n",
>  				err);
> -			goto err_clk_disable;
> +			goto err_phy_shutdown;
>  		}
>  	}
>  
> @@ -1189,6 +1189,12 @@ static int rcar_pcie_probe(struct platform_device *pdev)
>  	if (IS_ENABLED(CONFIG_PCI_MSI))
>  		rcar_pcie_teardown_msi(pcie);
>  
> +err_phy_shutdown:
> +	if (pcie->phy) {
> +		phy_power_off(pcie->phy);
> +		phy_exit(pcie->phy);
> +	}
> +
>  err_clk_disable:
>  	clk_disable_unprepare(pcie->bus_clk);
>  
> -- 
> 2.16.2
>
diff mbox

Patch

diff --git a/drivers/pci/host/pcie-rcar.c b/drivers/pci/host/pcie-rcar.c
index 636c3c5095d2..695781934f0a 100644
--- a/drivers/pci/host/pcie-rcar.c
+++ b/drivers/pci/host/pcie-rcar.c
@@ -1163,7 +1163,7 @@  static int rcar_pcie_probe(struct platform_device *pdev)
 	if (rcar_pcie_hw_init(pcie)) {
 		dev_info(dev, "PCIe link down\n");
 		err = -ENODEV;
-		goto err_clk_disable;
+		goto err_phy_shutdown;
 	}
 
 	data = rcar_pci_read_reg(pcie, MACSR);
@@ -1175,7 +1175,7 @@  static int rcar_pcie_probe(struct platform_device *pdev)
 			dev_err(dev,
 				"failed to enable MSI support: %d\n",
 				err);
-			goto err_clk_disable;
+			goto err_phy_shutdown;
 		}
 	}
 
@@ -1189,6 +1189,12 @@  static int rcar_pcie_probe(struct platform_device *pdev)
 	if (IS_ENABLED(CONFIG_PCI_MSI))
 		rcar_pcie_teardown_msi(pcie);
 
+err_phy_shutdown:
+	if (pcie->phy) {
+		phy_power_off(pcie->phy);
+		phy_exit(pcie->phy);
+	}
+
 err_clk_disable:
 	clk_disable_unprepare(pcie->bus_clk);