@@ -4,6 +4,8 @@
#include "bcm2835-rpi.dtsi"
#include "bcm283x-rpi-usb-peripheral.dtsi"
+#include <dt-bindings/reset/raspberrypi,firmware-reset.h>
+
/ {
compatible = "raspberrypi,4-model-b", "brcm,bcm2711";
model = "Raspberry Pi 4 Model B";
@@ -207,6 +209,21 @@ phy1: ethernet-phy@1 {
};
};
+&pcie0 {
+ pci@1,0 {
+ #address-cells = <3>;
+ #size-cells = <2>;
+ ranges;
+
+ reg = <0 0 0 0 0>;
+
+ usb@1,0 {
+ reg = <0x10000 0 0 0 0>;
+ resets = <&reset RASPBERRYPI_FIRMWARE_RESET_ID_USB>;
+ };
+ };
+};
+
/* uart0 communicates with the BT module */
&uart0 {
pinctrl-names = "default";
The chip is hardwired to the board's PCIe bus and needs to be properly setup trough a firmware routine after a PCI fundamental reset. Pass the reset controller phandle that takes care of triggering the initialization to the relevant PCI device. Signed-off-by: Nicolas Saenz Julienne <nsaenzjulienne@suse.de> --- Changes since v3: - Correctly define PCIe topology: [0000:00]---00.0-[01]----00.0 VIA Technologies, Inc. VL805 USB 3.0 Host Controller Earlier versions were not taking into account the bridge between the PCIe controller and xHCI controller. It worked, but out of luck... Changes since v2: - Use dt-bindings to access IDs Changes since v1: - Update to match new binding arch/arm/boot/dts/bcm2711-rpi-4-b.dts | 17 +++++++++++++++++ 1 file changed, 17 insertions(+)