@@ -8,6 +8,7 @@
* Author: Jingoo Han <jg1.han@samsung.com>
*/
+#include <linux/iopoll.h>
#include <linux/irqchip/chained_irq.h>
#include <linux/irqdomain.h>
#include <linux/msi.h>
@@ -807,3 +808,97 @@ int dw_pcie_setup_rc(struct dw_pcie_rp *pp)
return 0;
}
EXPORT_SYMBOL_GPL(dw_pcie_setup_rc);
+
+/*
+ * This resemble the pci_set_power_state() interfaces, but these are for
+ * configuring host controllers, which are bridges *to* PCI devices but
+ * are not PCI devices themselves.
+ */
+static void dw_pcie_set_dstate(struct dw_pcie *pci, pci_power_t dstate)
+{
+ u8 offset = dw_pcie_find_capability(pci, PCI_CAP_ID_PM);
+ u32 val;
+
+ val = dw_pcie_readw_dbi(pci, offset + PCI_PM_CTRL);
+ val &= ~PCI_PM_CTRL_STATE_MASK;
+ val |= dstate;
+ dw_pcie_writew_dbi(pci, offset + PCI_PM_CTRL, val);
+}
+
+int dw_pcie_suspend_noirq(struct dw_pcie *pci)
+{
+ u8 offset;
+ u32 val;
+ int ret;
+
+ offset = dw_pcie_find_capability(pci, PCI_CAP_ID_EXP);
+ /*
+ * If L1.1\L1.2 enable, devices (such as NVME) want short
+ * resume latency, controller will not enter L2
+ */
+ if (dw_pcie_readw_dbi(pci, offset + PCI_EXP_LNKCTL) & PCI_EXP_LNKCTL_ASPM_L1)
+ return 0;
+
+ if (dw_pcie_get_ltssm(pci) <= DW_PCIE_LTSSM_DETECT_ACT)
+ return 0;
+
+ if (!pci->pp.ops->pme_turn_off)
+ return -EINVAL;
+
+ pci->pp.ops->pme_turn_off(&pci->pp);
+
+ /*
+ * PCI Express Base Specification Rev 4.0
+ * 5.3.3.2.1 PME Synchronization
+ * Recommand 1ms to 10ms timeout to check L2 ready
+ */
+ ret = read_poll_timeout(dw_pcie_get_ltssm, val, val == DW_PCIE_LTSSM_L2_IDLE,
+ 100, 10000, false, pci);
+ if (ret) {
+ dev_err(pci->dev, "PCIe link enter L2 timeout! ltssm = 0x%x\n", val);
+ return ret;
+ }
+
+ dw_pcie_set_dstate(pci, PCI_D3hot);
+
+ pci->suspended = true;
+
+ return ret;
+}
+EXPORT_SYMBOL_GPL(dw_pcie_suspend_noirq);
+
+int dw_pcie_resume_noirq(struct dw_pcie *pci)
+{
+ int ret;
+
+ if (!pci->suspended)
+ return 0;
+
+ pci->suspended = false;
+
+ dw_pcie_set_dstate(pci, PCI_D0);
+
+ if (!pci->pp.ops->exit_from_l2)
+ return -EINVAL;
+
+ pci->pp.ops->exit_from_l2(&pci->pp);
+
+ ret = pci->pp.ops->host_init(&pci->pp);
+ if (ret) {
+ dev_err(pci->dev, "Host init failed! ret = 0x%x\n", ret);
+ return ret;
+ }
+
+ dw_pcie_setup_rc(&pci->pp);
+
+ ret = dw_pcie_start_link(pci);
+ if (ret)
+ return ret;
+
+ ret = dw_pcie_wait_for_link(pci);
+ if (ret)
+ return ret;
+
+ return ret;
+}
+EXPORT_SYMBOL_GPL(dw_pcie_resume_noirq);
@@ -288,10 +288,21 @@ enum dw_pcie_core_rst {
DW_PCIE_NUM_CORE_RSTS
};
+enum dw_pcie_ltssm {
+ DW_PCIE_LTSSM_UNKNOWN = 0xFFFFFFFF,
+ /* Need align PCIE_PORT_DEBUG0 bit0:5 */
+ DW_PCIE_LTSSM_DETECT_QUIET = 0x0,
+ DW_PCIE_LTSSM_DETECT_ACT = 0x1,
+ DW_PCIE_LTSSM_L0 = 0x11,
+ DW_PCIE_LTSSM_L2_IDLE = 0x15,
+};
+
struct dw_pcie_host_ops {
int (*host_init)(struct dw_pcie_rp *pp);
void (*host_deinit)(struct dw_pcie_rp *pp);
int (*msi_host_init)(struct dw_pcie_rp *pp);
+ void (*pme_turn_off)(struct dw_pcie_rp *pp);
+ void (*exit_from_l2)(struct dw_pcie_rp *pp);
};
struct dw_pcie_rp {
@@ -364,6 +375,7 @@ struct dw_pcie_ops {
void (*write_dbi2)(struct dw_pcie *pcie, void __iomem *base, u32 reg,
size_t size, u32 val);
int (*link_up)(struct dw_pcie *pcie);
+ enum dw_pcie_ltssm (*get_ltssm)(struct dw_pcie *pcie);
int (*start_link)(struct dw_pcie *pcie);
void (*stop_link)(struct dw_pcie *pcie);
};
@@ -393,6 +405,7 @@ struct dw_pcie {
struct reset_control_bulk_data app_rsts[DW_PCIE_NUM_APP_RSTS];
struct reset_control_bulk_data core_rsts[DW_PCIE_NUM_CORE_RSTS];
struct gpio_desc *pe_rst;
+ bool suspended;
};
#define to_dw_pcie_from_pp(port) container_of((port), struct dw_pcie, pp)
@@ -430,6 +443,9 @@ void dw_pcie_iatu_detect(struct dw_pcie *pci);
int dw_pcie_edma_detect(struct dw_pcie *pci);
void dw_pcie_edma_remove(struct dw_pcie *pci);
+int dw_pcie_suspend_noirq(struct dw_pcie *pci);
+int dw_pcie_resume_noirq(struct dw_pcie *pci);
+
static inline void dw_pcie_writel_dbi(struct dw_pcie *pci, u32 reg, u32 val)
{
dw_pcie_write_dbi(pci, reg, 0x4, val);
@@ -501,6 +517,18 @@ static inline void dw_pcie_stop_link(struct dw_pcie *pci)
pci->ops->stop_link(pci);
}
+static inline enum dw_pcie_ltssm dw_pcie_get_ltssm(struct dw_pcie *pci)
+{
+ u32 val;
+
+ if (pci->ops && pci->ops->get_ltssm)
+ return pci->ops->get_ltssm(pci);
+
+ val = dw_pcie_readl_dbi(pci, PCIE_PORT_DEBUG0);
+
+ return (enum dw_pcie_ltssm)FIELD_GET(PORT_LOGIC_LTSSM_STATE_MASK, val);
+}
+
#ifdef CONFIG_PCIE_DW_HOST
irqreturn_t dw_handle_msi_irq(struct dw_pcie_rp *pp);
int dw_pcie_setup_rc(struct dw_pcie_rp *pp);
Introduced helper function dw_pcie_get_ltssm to retrieve SMLH_LTSS_STATE. Added API pme_turn_off and exit_from_l2 for managing L2/L3 state transitions. Typical L2 entry workflow: 1. Transmit PME turn off signal to PCI devices and wait for PME_To_Ack. 2. Await link entering L2_IDLE state. 3. Transition Root complex to D3 state. Typical L2 exit workflow: 1. Transition Root complex to D0 state. 2. Issue exit from L2 command. 3. Reinitialize PCI host. 4. Wait for link to become active. Signed-off-by: Frank Li <Frank.Li@nxp.com> --- Change from v3 to v4: - change according to Manivannan's comments. I hope I have not missed anything. quite long discuss thread Change from v2 to v3: - Basic rewrite whole patch according rob herry suggestion. put common function into dwc, so more soc can share the same logic. .../pci/controller/dwc/pcie-designware-host.c | 95 +++++++++++++++++++ drivers/pci/controller/dwc/pcie-designware.h | 28 ++++++ 2 files changed, 123 insertions(+)