@@ -633,10 +633,38 @@ static void __init disable_pgtable_l4(void)
* then read SATP to see if the configuration was taken into account
* meaning sv48 is supported.
*/
-static __init void set_satp_mode(void)
+static __init void set_satp_mode(uintptr_t dtb_pa)
{
u64 identity_satp, hw_satp;
uintptr_t set_satp_mode_pmd;
+#ifndef CONFIG_KASAN
+ /*
+ * The below fdt functions are kasan instrumented, since at this point
+ * there is no mapping for the kasan shadow memory, this can't be used
+ * when kasan is enabled otherwise it traps.
+ */
+ int cpus_node;
+
+ /* Check if the user asked for sv39 explicitly in the device tree */
+ cpus_node = fdt_path_offset((void *)dtb_pa, "/cpus");
+ if (cpus_node >= 0) {
+ int node;
+
+ fdt_for_each_subnode(node, (void *)dtb_pa, cpus_node) {
+ const char *mmu_type = fdt_getprop((void *)dtb_pa, node,
+ "mmu-type", NULL);
+ if (!mmu_type)
+ continue;
+
+ if (!strcmp(mmu_type, "riscv,sv39")) {
+ disable_pgtable_l4();
+ return;
+ }
+
+ break;
+ }
+ }
+#endif
set_satp_mode_pmd = ((unsigned long)set_satp_mode) & PMD_MASK;
create_pgd_mapping(early_pg_dir,
@@ -838,7 +866,7 @@ asmlinkage void __init setup_vm(uintptr_t dtb_pa)
#endif
#if defined(CONFIG_64BIT) && !defined(CONFIG_XIP_KERNEL)
- set_satp_mode();
+ set_satp_mode(dtb_pa);
#endif
kernel_map.va_pa_offset = PAGE_OFFSET - kernel_map.phys_addr;
This is made possible by using the mmu-type property of the cpu node of the device tree. By default, the kernel will boot with 4-level page table if the hw supports it but it can be interesting for the user to select 3-level page table as it is less memory consuming and faster since it requires less memory accesses in case of a TLB miss. This functionality requires that kasan is disabled since calling the fdt functions that are kasan instrumented with the MMU off can't work. Signed-off-by: Alexandre Ghiti <alexandre.ghiti@canonical.com> --- arch/riscv/mm/init.c | 32 ++++++++++++++++++++++++++++++-- 1 file changed, 30 insertions(+), 2 deletions(-)