riscv: dts: starfive: jh7110-milkv-mars: set host mode and vbus pin for on-chip USB 2.0

Commit Message

E Shattow Nov. 14, 2024, 8:13 p.m. UTC

Enable host mode USB for Milk-V Mars by setting host mode and connect vbus 
pinctrl.

Note that testing this functionality depends on two features:

1.  commit e10c52e7e064038d9bd67b20bf4ce92077d7d84e "phy: starfive: 
jh7110-usb: Fix link configuration to controller"

2. Setting the USB over-current register to disable. This is done at 
bootloader phase, for example U-Boot: 
https://patchwork.ozlabs.org/project/uboot/patch/[e-mail]/

If the over-current register is not prepared for us then the result is no 
change in functional outcome with this patch applied; there is an error 
visible to the user and usb configuration fails (same as it is now).

Signed-off-by: E Shattow <[e-mail]>
---
 .../boot/dts/starfive/jh7110-milkv-mars.dts    | 18 +++++++++++++++++-
 1 file changed, 17 insertions(+), 1 deletion(-)

Patch

diff --git a/arch/riscv/boot/dts/starfive/jh7110-milkv-mars.dts b/arch/riscv/boot/dts/starfive/jh7110-milkv-mars.dts
index 0d248b671d4b..bddfc7c6b00f 100644
--- a/arch/riscv/boot/dts/starfive/jh7110-milkv-mars.dts
+++ b/arch/riscv/boot/dts/starfive/jh7110-milkv-mars.dts
@@ -53,7 +53,23 @@  &spi0 {
 	status = "okay";
 };
 
+&sysgpio {
+	usb_pins: usb0-0 {
+		driver-vbus-pin {
+			pinmux = <GPIOMUX(25, GPOUT_SYS_USB_DRIVE_VBUS,
+					      GPOEN_ENABLE,
+					      GPI_NONE)>;
+			bias-disable;
+			input-disable;
+			input-schmitt-disable;
+			slew-rate = <0>;
+		};
+	};
+};
+
 &usb0 {
-	dr_mode = "peripheral";
+	dr_mode = "host";
+	pinctrl-names = "default";
+	pinctrl-0 = <&usb_pins>;
 	status = "okay";
 };