mbox series

[GIT,PULL] Qualcomm ARM64 DT updates for v5.8

Message ID 20200519052528.1249950-1-bjorn.andersson@linaro.org (mailing list archive)
State Mainlined, archived
Commit 7d2f29e49477aa51339e719cf73f0945c39c8a9e
Headers show
Series [GIT,PULL] Qualcomm ARM64 DT updates for v5.8 | expand

Pull-request

https://git.kernel.org/pub/scm/linux/kernel/git/qcom/linux.git tags/qcom-arm64-for-5.8

Message

Bjorn Andersson May 19, 2020, 5:25 a.m. UTC 
The following changes since commit 8f3d9f354286745c751374f5f1fcafee6b3f3136:

  Linux 5.7-rc1 (2020-04-12 12:35:55 -0700)

are available in the Git repository at:

  https://git.kernel.org/pub/scm/linux/kernel/git/qcom/linux.git tags/qcom-arm64-for-5.8

for you to fetch changes up to 7d2f29e49477aa51339e719cf73f0945c39c8a9e:

  arm64: dts: qcom: sc7180: Correct the pdc interrupt ranges (2020-05-18 20:08:35 -0700)

----------------------------------------------------------------
Qualcomm ARM64 DT updates for v5.8

For SDM845 this defines the IPA network accelerator and the CCI camera
control bus, it defines the required UFS reset and adds WiFi for the
Lenovo Yoga C630 and defines GPIO pin names and adds OV8856 and OC7251
camera nodes for DB845c.

For SC7180 it adds GPU support, defines the modem remoteproc, adds the
IPA network accelerator, Coresight and ETM support, adds cpuidle low
power states and updates the CPUs' compatible.

For SM8250 it adds regulators from the PM8150, PM8150L and PM8009 and
adds voltage corners, it defines the nodes for UFS PHY and controller
and finally corrects a typo in the PDC node to make SPMI functional.

For MSM8916 I2C1 and I2C5 are defined, a node for the CCI camera control
interface bus is added and Coresight is disabled by default to match
some product configurations. The Samsung A3U gained display support and
Samsung A5U gained touchscreen support.

MSM8996 now property describes the power supply chain for the GPU, the
CCI camera control interface bus is added and the DB820c has the
regulators of the secondary PMIC defined.

For QCS404 USB PHYs and controllers are defined and wired up for the
EVB.

SDM630/SDM660 platform support is added and the Xiaomi Redmi Note 7
defined.

It also contains a number of changes throughout to improve DT binding
compliance.

----------------------------------------------------------------
Alex Elder (2):
      arm64: dts: sdm845: add IPA iommus property
      arm64: dts: qcom: sc7180: add IPA information

Alexey Minnekhanov (2):
      dt-bindings: arm: qcom: Add sdm630 and sdm660 SoCs
      arm64: dts: qcom: Add Xiaomi Redmi Note 7 (lavender)

Amit Kucheria (5):
      dt-bindings: arm: cpus: Add kryo468 compatible
      arm64: dts: qcom: sc7180: Fix cpu compatible
      arm64: dts: qcom: msm8916: remove unit name for thermal trip points
      arm64: dts: qcom: msm8996: remove unit name for thermal trip points
      arm64: dts: qcom: msm8998: remove unit name for thermal trip points

Bjorn Andersson (9):
      arm64: dts: qcom: qcs404: Add USB devices and PHYs
      arm64: dts: qcom: sm8250: Add rpmhpd node
      arm64: dts: qcom: sm8250: Fix PDC compatible and reg
      arm64: dts: qcom: db820c: Add pmi8994 RPM regulators
      arm64: dts: qcom: db820c: Fix invalid pm8994 supplies
      arm64: dts: qcom: c630: Add WiFi node
      arm64: dts: qcom: c630: Specify UFS device reset
      arm64: dts: qcom: msm8996: Make GPU node control GPU_GX GDSC
      arm64: dts: qcom: sc7180: Fix ETMv4 power management patch

Bryan O'Donoghue (7):
      arm64: dts: qcom: qcs404-evb: Define VBUS pins
      arm64: dts: qcom: qcs404-evb: Define USB ID pin
      arm64: dts: qcom: qcs404-evb: Describe external VBUS regulator
      arm64: dts: qcom: qcs404-evb: Raise vreg_l12_3p3 minimum voltage
      arm64: dts: qcom: qcs404-evb: Enable USB controllers
      arm64: dts: qcom: sm8250-mtp: Add pm8150, pm8150l and pm8009
      arm64: dts: qcom: sm8250: Add UFS controller and PHY

Craig Tatlor (1):
      arm64: dts: qcom: Add SDM660 SoC support

Douglas Anderson (3):
      arm64: dts: qcom: sc7180: Swap order of gpucc and sdhc_2
      arm64: dts: sdm845: Add "no-hpd" to sn65dsi86 on cheza
      arm64: dts: qcom: sc7180: Add "no-map" to cmd_db reserved area

Evan Green (1):
      arm64: dts: qcom: sc7180: Include interconnect definitions

Jonathan Marek (1):
      arm64: dts: qcom: fix pm8150 gpio interrupts

Krishna Manikandan (1):
      arm64: dts: qcom: sc7180: modify assigned clocks for sc7180 target

Loic Poulain (4):
      arm64: dts: qcom: msm8916: Add i2c-qcom-cci node
      arm64: dts: qcom: apq8016-sbc: Add CCI/Sensor nodes
      arm64: dts: msm8996: Fix CSI IRQ types
      arch: arm64: dts: msm8996: Add CCI node

Matthias Kaehlcke (1):
      arm64: dts: qcom: sc7180: Add interconnect paths for the video codec

Maulik Shah (2):
      arm64: dts: qcom: sc7180: Add cpuidle low power states
      arm64: dts: qcom: sc7180: Correct the pdc interrupt ranges

Michael Srba (2):
      arm64: dts: qcom: msm8916: Disable coresight by default
      arm64: dts: qcom: msm8916-samsung-a3u: add nodes for display panel

Mike Leach (1):
      arm64: dts: qcom: msm8916: Add CTI options

Rajendra Nayak (1):
      arm64: dts: qcom: db820c: Add vdd_gfx and tie it into mmcc

Rajeshwari (1):
      arm64: dts: qcom: sc7180: Changed polling mode in Thermal-zones node

Robert Foss (3):
      arm64: dts: qcom: sdm845: Add i2c-qcom-cci node
      arm64: dts: qcom: sdm845-db845c: Add pm_8998 gpio names
      arm64: dts: qcom: sdm845-db845c: Add ov8856 & ov7251 camera nodes

Sai Prakash Ranjan (2):
      arm64: dts: qcom: sc7180: Add Coresight support
      arm64: dts: qcom: sc7180: Support ETMv4 power management

Sandeep Maheswaram (3):
      arm64: dts: qcom: sdm845: Add generic QUSB2 V2 Phy compatible
      arm64: dts: qcom: sc7180: Add generic QUSB2 V2 Phy compatible
      arm64: dts: qcom: sc7180: Update QUSB2 V2 Phy params for SC7180 IDP device

Sharat Masetty (2):
      dt-bindings: arm-smmu: Add sc7180 compatible string
      arm64: dts: qcom: sc7180: Add A618 gpu dt blob

Sibi Sankar (4):
      arm64: dts: qcom: sdm845: Add SoC compatible to MTP
      arm64: dts: qcom: sc7180: Update reserved memory map
      arm64: dts: qcom: sc7180: Add Q6V5 MSS node
      arm64: dts: qcom: sc7180: Update Q6V5 MSS node

Sivaprakash Murugesan (1):
      arm64: dts: ipq8074: qcom: Re-arrange dts nodes based on address

Stephan Gerhold (7):
      arm64: dts: qcom: msm8916: Add blsp_i2c1
      arm64: dts: qcom: msm8916: Add blsp_i2c5
      arm64: dts: qcom: msm8916-samsung-a2015: Add touchscreen regulator
      arm64: dts: qcom: msm8916-samsung-a5u: Add touchscreen
      arm64: dts: qcom: msm8916: avoid using _ in node names
      arm64: dts: qcom: msm8916: move gpu opp table to gpu node
      arm64: dts: qcom: apq8016-sbc: merge -pins.dtsi into main .dtsi

Ulf Hansson (2):
      arm64: dts: qcom: msm8916: Conform to the domain-idle-state binding
      arm64: dts: qcom: msm8916: Conform to the nodename pattern PSCI subnodes

 Documentation/devicetree/bindings/arm/cpus.yaml    |   1 +
 Documentation/devicetree/bindings/arm/qcom.yaml    |   7 +
 .../devicetree/bindings/iommu/arm,smmu.yaml        |   1 +
 arch/arm64/boot/dts/qcom/Makefile                  |   1 +
 .../arm64/boot/dts/qcom/apq8016-sbc-pmic-pins.dtsi |  74 --
 arch/arm64/boot/dts/qcom/apq8016-sbc-soc-pins.dtsi |  89 --
 arch/arm64/boot/dts/qcom/apq8016-sbc.dtsi          | 257 +++++-
 arch/arm64/boot/dts/qcom/apq8096-db820c.dtsi       |  53 +-
 arch/arm64/boot/dts/qcom/ipq8074-hk01.dts          | 112 ++-
 arch/arm64/boot/dts/qcom/ipq8074.dtsi              | 474 +++++-----
 .../boot/dts/qcom/msm8916-longcheer-l8150.dts      |  25 +-
 arch/arm64/boot/dts/qcom/msm8916-pins.dtsi         | 221 +++--
 .../dts/qcom/msm8916-samsung-a2015-common.dtsi     |  98 ++-
 .../boot/dts/qcom/msm8916-samsung-a3u-eur.dts      |  54 ++
 .../boot/dts/qcom/msm8916-samsung-a5u-eur.dts      |  35 +
 arch/arm64/boot/dts/qcom/msm8916.dtsi              | 228 ++++-
 arch/arm64/boot/dts/qcom/msm8996.dtsi              |  87 +-
 arch/arm64/boot/dts/qcom/msm8998.dtsi              |  38 +-
 arch/arm64/boot/dts/qcom/pm8150.dtsi               |  14 +-
 arch/arm64/boot/dts/qcom/pm8150b.dtsi              |  14 +-
 arch/arm64/boot/dts/qcom/pm8150l.dtsi              |  14 +-
 arch/arm64/boot/dts/qcom/pmi8994.dtsi              |   6 +
 arch/arm64/boot/dts/qcom/qcs404-evb.dtsi           |  85 +-
 arch/arm64/boot/dts/qcom/qcs404.dtsi               | 100 +++
 arch/arm64/boot/dts/qcom/sc7180-idp.dts            |  66 +-
 arch/arm64/boot/dts/qcom/sc7180.dtsi               | 955 +++++++++++++++++++--
 .../arm64/boot/dts/qcom/sdm660-xiaomi-lavender.dts |  46 +
 arch/arm64/boot/dts/qcom/sdm660.dtsi               | 372 ++++++++
 arch/arm64/boot/dts/qcom/sdm845-cheza.dtsi         |   2 +
 arch/arm64/boot/dts/qcom/sdm845-db845c.dts         | 210 +++++
 arch/arm64/boot/dts/qcom/sdm845-mtp.dts            |   2 +-
 arch/arm64/boot/dts/qcom/sdm845.dtsi               |  98 ++-
 .../boot/dts/qcom/sdm850-lenovo-yoga-c630.dts      |  13 +
 arch/arm64/boot/dts/qcom/sm8250-mtp.dts            | 351 ++++++++
 arch/arm64/boot/dts/qcom/sm8250.dtsi               | 126 ++-
 35 files changed, 3528 insertions(+), 801 deletions(-)
 delete mode 100644 arch/arm64/boot/dts/qcom/apq8016-sbc-pmic-pins.dtsi
 delete mode 100644 arch/arm64/boot/dts/qcom/apq8016-sbc-soc-pins.dtsi
 create mode 100644 arch/arm64/boot/dts/qcom/sdm660-xiaomi-lavender.dts
 create mode 100644 arch/arm64/boot/dts/qcom/sdm660.dtsi