[GIT,PULL] RISC-V Devicetrees for v6.9

Pull-request

https://git.kernel.org/pub/scm/linux/kernel/git/conor/linux.git/ tags/riscv-dt-for-v6.9

Message

Conor Dooley March 5, 2024, 7:55 p.m. UTC

Hey Arnd,

I'm a little late this time around, meant to send this before -rc8,
but I ended up crashing my bike in the surprise bad weather we had
here on Friday and didn't do anything for the weekend at all.

There's some binding stuff here that Uwe didn't want to take in PWM
and then a follow-up patch that ended up in my tree because the original
was not in his... I'm gonna try to avoid something like that happening
again, I' prob just send that sort of thing via Rob in the future.

Thanks,
Conor.

The following changes since commit 6613476e225e090cc9aad49be7fa504e290dd33d:

  Linux 6.8-rc1 (2024-01-21 14:11:32 -0800)

are available in the Git repository at:

  https://git.kernel.org/pub/scm/linux/kernel/git/conor/linux.git/ tags/riscv-dt-for-v6.9

for you to fetch changes up to 28ecaaa5af192fa8a3f406e5a3e5416324c4d0a5:

  riscv: dts: starfive: jh7110: Add camera subsystem nodes (2024-03-01 16:12:26 +0000)

----------------------------------------------------------------
RISC-V Devicetrees for v6.9

Microchip:
Missing bus clocks for the CAN controllers spotted during the creation
of a driver for the controllers and a specific compatible for the SiFive
PDMA block on PolarFire SoC.

Starfive:
PWM nodes for the jh7100 and jh7110. Camera subsystem support for the
latter. Most notably however is the addition of ethernet support for the
jh7110 which finally allows people to use the network on the OG VisionFive
and on the Beagle-V Starlight board. This was made possible by the
non-standard cache management operations support added for the RZ/Five
which could be extended to the ccache present on the jh7100.

bindings:
Additional clarification for what the reg property represents for cpus
and two opencores PWM binding changes - the original addition and an
added compatible. The latter is here as the driver patch was not ready
but the PWM maintainer told me to go ahead and merge it.

Signed-off-by: Conor Dooley <[e-mail]>

----------------------------------------------------------------
Changhuang Liang (1):
      riscv: dts: starfive: jh7110: Add camera subsystem nodes

Conor Dooley (1):
      riscv: dts: microchip: add missing CAN bus clocks

Cristian Ciocaltea (4):
      riscv: dts: starfive: jh7100: Add sysmain and gmac DT nodes
      riscv: dts: starfive: jh7100-common: Setup pinmux and enable gmac
      riscv: dts: starfive: visionfive-v1: Setup ethernet phy
      riscv: dts: starfive: beaglev-starlight: Setup phy reset gpio

Heinrich Schuchardt (1):
      dt-bindings: riscv: cpus: reg matches hart ID

Ji Sheng Teoh (1):
      dt-bindings: pwm: opencores: Add compatible for StarFive JH8100

Shravan Chippa (1):
      riscv: dts: microchip: add specific compatible for mpfs pdma

William Qiu (3):
      dt-bindings: pwm: Add bindings for OpenCores PWM Controller
      riscv: dts: starfive: jh7100: Add PWM node and pins configuration
      riscv: dts: starfive: jh7110: Add PWM node and pins configuration

 .../devicetree/bindings/pwm/opencores,pwm.yaml     |  56 +++++++++++
 Documentation/devicetree/bindings/riscv/cpus.yaml  |   4 +
 arch/riscv/boot/dts/microchip/mpfs.dtsi            |   6 +-
 .../boot/dts/starfive/jh7100-beaglev-starlight.dts |  11 +++
 arch/riscv/boot/dts/starfive/jh7100-common.dtsi    | 108 +++++++++++++++++++++
 .../dts/starfive/jh7100-starfive-visionfive-v1.dts |  22 ++++-
 arch/riscv/boot/dts/starfive/jh7100.dtsi           |  45 +++++++++
 .../dts/starfive/jh7110-starfive-visionfive-2.dtsi |  71 ++++++++++++++
 arch/riscv/boot/dts/starfive/jh7110.dtsi           |  76 +++++++++++++++
 9 files changed, 395 insertions(+), 4 deletions(-)
 create mode 100644 Documentation/devicetree/bindings/pwm/opencores,pwm.yaml

Comments

[e-mail] March 6, 2024, 7 a.m. UTC | #1

Hello:

This pull request was applied to soc/soc.git (for-next)
by Arnd Bergmann <[e-mail]>:

On Tue, 5 Mar 2024 19:55:27 +0000 you wrote:
> Hey Arnd,
> 
> I'm a little late this time around, meant to send this before -rc8,
> but I ended up crashing my bike in the surprise bad weather we had
> here on Friday and didn't do anything for the weekend at all.
> 
> There's some binding stuff here that Uwe didn't want to take in PWM
> and then a follow-up patch that ended up in my tree because the original
> was not in his... I'm gonna try to avoid something like that happening
> again, I' prob just send that sort of thing via Rob in the future.
> 
> [...]

Here is the summary with links:
  - [GIT,PULL] RISC-V Devicetrees for v6.9
    https://git.kernel.org/soc/soc/c/ee7dad0b8181

You are awesome, thank you!