@@ -120,16 +120,14 @@ static int ath_ahb_probe(struct platform_device *pdev)
sc->irq = irq;
ret = ath_init_device(AR5416_AR9100_DEVID, sc);
- if (ret != 0) {
- dev_err(&pdev->dev, "failed to attach device, err=%d\n", ret);
- ret = -ENODEV;
+ if (ret) {
+ dev_err(&pdev->dev, "failed to initialize device\n");
goto err_free_hw;
}
ret = request_irq(irq, ath_isr, IRQF_SHARED, "ath9k", sc);
if (ret) {
- dev_err(&pdev->dev, "request_irq failed, err=%d\n", ret);
- ret = -EIO;
+ dev_err(&pdev->dev, "request_irq failed\n");
goto err_detach;
}
@@ -179,17 +179,17 @@ static int ath_pci_probe(struct pci_dev *pdev, const struct pci_device_id *id)
sc->mem = mem;
sc->bus_ops = &ath_pci_bus_ops;
- if (ath_init_device(id->device, sc) != 0) {
- ret = -ENODEV;
+ ret = ath_init_device(id->device, sc);
+ if (ret) {
+ dev_err(&pdev->dev, "failed to initialize device\n");
goto bad3;
}
/* setup interrupt service routine */
- if (request_irq(pdev->irq, ath_isr, IRQF_SHARED, "ath", sc)) {
- printk(KERN_ERR "%s: request_irq failed\n",
- wiphy_name(hw->wiphy));
- ret = -EIO;
+ ret = request_irq(pdev->irq, ath_isr, IRQF_SHARED, "ath", sc);
+ if (ret) {
+ dev_err(&pdev->dev, "request_irq failed\n");
goto bad4;
}
We've cleaned up ath_init_device() and its children enough to pass meaninful errors back from probe. When this fails it means our device could not be initialized and a meaninful error will have been passed. Do the same for request_irq() and also synchronize the error messages while at it. Signed-off-by: Luis R. Rodriguez <lrodriguez@atheros.com> --- drivers/net/wireless/ath/ath9k/ahb.c | 8 +++----- drivers/net/wireless/ath/ath9k/pci.c | 12 ++++++------ 2 files changed, 9 insertions(+), 11 deletions(-)