@@ -3932,8 +3932,7 @@ static int iwl_pci_probe(struct pci_dev *pdev, const struct pci_device_id *ent)
struct ieee80211_hw *hw;
struct iwl_cfg *cfg = (struct iwl_cfg *)(ent->driver_data);
unsigned long flags;
- u16 pci_cmd;
- u8 perm_addr[ETH_ALEN];
+ u16 pci_cmd, num_mac;
/************************
* 1. Allocating HW data
@@ -4051,9 +4050,17 @@ static int iwl_pci_probe(struct pci_dev *pdev, const struct pci_device_id *ent)
goto out_free_eeprom;
/* extract MAC Address */
- iwl_eeprom_get_mac(priv, perm_addr);
- IWL_DEBUG_INFO(priv, "MAC address: %pM\n", perm_addr);
- SET_IEEE80211_PERM_ADDR(priv->hw, perm_addr);
+ iwl_eeprom_get_mac(priv, priv->addresses[0].addr);
+ IWL_DEBUG_INFO(priv, "MAC address: %pM\n", priv->addresses[0].addr);
+ priv->hw->wiphy->addresses = priv->addresses;
+ priv->hw->wiphy->n_addresses = 1;
+ num_mac = iwl_eeprom_query16(priv, EEPROM_NUM_MAC_ADDRESS);
+ if (num_mac > 1) {
+ memcpy(priv->addresses[1].addr, priv->addresses[0].addr,
+ ETH_ALEN);
+ priv->addresses[1].addr[5]++;
+ priv->hw->wiphy->n_addresses++;
+ }
/************************
* 5. Setup HW constants
@@ -1154,6 +1154,9 @@ struct iwl_priv {
u32 hw_wa_rev;
u8 rev_id;
+ /* EEPROM MAC addresses */
+ struct mac_address addresses[2];
+
/* uCode images, save to reload in case of failure */
int fw_index; /* firmware we're trying to load */
u32 ucode_ver; /* version of ucode, copy of
@@ -402,6 +402,7 @@ struct iwl_eeprom_calib_info {
#define EEPROM_WOWLAN_MODE (2*0x47) /* 2 bytes */
#define EEPROM_RADIO_CONFIG (2*0x48) /* 2 bytes */
#define EEPROM_3945_M_VERSION (2*0x4A) /* 1 bytes */
+#define EEPROM_NUM_MAC_ADDRESS (2*0x4C) /* 2 bytes */
/* The following masks are to be applied on EEPROM_RADIO_CONFIG */
#define EEPROM_RF_CFG_TYPE_MSK(x) (x & 0x3) /* bits 0-1 */