@@ -732,8 +732,128 @@ static inline u8 find_first_chain(u8 mask)
return CHAIN_C;
}
+/**
+ * Run disconnected antenna algorithm to find out which antennas are
+ * disconnected.
+ */
+static void iwl_find_disconn_antenna(struct iwl_priv *priv, u32* average_sig,
+ struct iwl_chain_noise_data *data)
+{
+ u32 active_chains = 0;
+ u32 max_average_sig;
+ u16 max_average_sig_antenna_i;
+ u8 num_tx_chains;
+ u8 first_chain;
+ u16 i = 0;
+
+ average_sig[0] = data->chain_signal_a /
+ priv->cfg->base_params->chain_noise_num_beacons;
+ average_sig[1] = data->chain_signal_b /
+ priv->cfg->base_params->chain_noise_num_beacons;
+ average_sig[2] = data->chain_signal_c /
+ priv->cfg->base_params->chain_noise_num_beacons;
+
+ if (average_sig[0] >= average_sig[1]) {
+ max_average_sig = average_sig[0];
+ max_average_sig_antenna_i = 0;
+ active_chains = (1 << max_average_sig_antenna_i);
+ } else {
+ max_average_sig = average_sig[1];
+ max_average_sig_antenna_i = 1;
+ active_chains = (1 << max_average_sig_antenna_i);
+ }
+
+ if (average_sig[2] >= max_average_sig) {
+ max_average_sig = average_sig[2];
+ max_average_sig_antenna_i = 2;
+ active_chains = (1 << max_average_sig_antenna_i);
+ }
+
+ IWL_DEBUG_CALIB(priv, "average_sig: a %d b %d c %d\n",
+ average_sig[0], average_sig[1], average_sig[2]);
+ IWL_DEBUG_CALIB(priv, "max_average_sig = %d, antenna %d\n",
+ max_average_sig, max_average_sig_antenna_i);
+
+ /* Compare signal strengths for all 3 receivers. */
+ for (i = 0; i < NUM_RX_CHAINS; i++) {
+ if (i != max_average_sig_antenna_i) {
+ s32 rssi_delta = (max_average_sig - average_sig[i]);
+
+ /* If signal is very weak, compared with
+ * strongest, mark it as disconnected. */
+ if (rssi_delta > MAXIMUM_ALLOWED_PATHLOSS)
+ data->disconn_array[i] = 1;
+ else
+ active_chains |= (1 << i);
+ IWL_DEBUG_CALIB(priv, "i = %d rssiDelta = %d "
+ "disconn_array[i] = %d\n",
+ i, rssi_delta, data->disconn_array[i]);
+ }
+ }
+
+ /*
+ * The above algorithm sometimes fails when the ucode
+ * reports 0 for all chains. It's not clear why that
+ * happens to start with, but it is then causing trouble
+ * because this can make us enable more chains than the
+ * hardware really has.
+ *
+ * To be safe, simply mask out any chains that we know
+ * are not on the device.
+ */
+ if (priv->cfg->bt_params &&
+ priv->cfg->bt_params->advanced_bt_coexist &&
+ priv->bt_full_concurrent) {
+ /* operated as 1x1 in full concurrency mode */
+ active_chains &= first_antenna(priv->hw_params.valid_rx_ant);
+ } else
+ active_chains &= priv->hw_params.valid_rx_ant;
+
+ num_tx_chains = 0;
+ for (i = 0; i < NUM_RX_CHAINS; i++) {
+ /* loops on all the bits of
+ * priv->hw_setting.valid_tx_ant */
+ u8 ant_msk = (1 << i);
+ if (!(priv->hw_params.valid_tx_ant & ant_msk))
+ continue;
+
+ num_tx_chains++;
+ if (data->disconn_array[i] == 0)
+ /* there is a Tx antenna connected */
+ break;
+ if (num_tx_chains == priv->hw_params.tx_chains_num &&
+ data->disconn_array[i]) {
+ /*
+ * If all chains are disconnected
+ * connect the first valid tx chain
+ */
+ first_chain =
+ find_first_chain(priv->cfg->valid_tx_ant);
+ data->disconn_array[first_chain] = 0;
+ active_chains |= BIT(first_chain);
+ IWL_DEBUG_CALIB(priv, "All Tx chains are disconnected \
+ W/A - declare %d as connected\n",
+ first_chain);
+ break;
+ }
+ }
+
+ if (active_chains != priv->hw_params.valid_rx_ant &&
+ active_chains != priv->chain_noise_data.active_chains)
+ IWL_DEBUG_CALIB(priv,
+ "Detected that not all antennas are connected! "
+ "Connected: %#x, valid: %#x.\n",
+ active_chains, priv->hw_params.valid_rx_ant);
+
+ /* Save for use within RXON, TX, SCAN commands, etc. */
+ data->active_chains = active_chains;
+ IWL_DEBUG_CALIB(priv, "active_chains (bitwise) = 0x%x\n",
+ active_chains);
+}
+
+
/*
- * Accumulate 20 beacons of signal and noise statistics for each of
+ * Accumulate 16 beacons of signal and noise statistics for each of
* 3 receivers/antennas/rx-chains, then figure out:
* 1) Which antennas are connected.
* 2) Differential rx gain settings to balance the 3 receivers.
@@ -750,8 +870,6 @@ void iwl_chain_noise_calibration(struct iwl_priv *priv, void *stat_resp)
u32 chain_sig_c;
u32 average_sig[NUM_RX_CHAINS] = {INITIALIZATION_VALUE};
u32 average_noise[NUM_RX_CHAINS] = {INITIALIZATION_VALUE};
- u32 max_average_sig;
- u16 max_average_sig_antenna_i;
u32 min_average_noise = MIN_AVERAGE_NOISE_MAX_VALUE;
u16 min_average_noise_antenna_i = INITIALIZATION_VALUE;
u16 i = 0;
@@ -759,11 +877,9 @@ void iwl_chain_noise_calibration(struct iwl_priv *priv, void *stat_resp)
u16 stat_chnum = INITIALIZATION_VALUE;
u8 rxon_band24;
u8 stat_band24;
- u32 active_chains = 0;
- u8 num_tx_chains;
unsigned long flags;
struct statistics_rx_non_phy *rx_info;
- u8 first_chain;
+
/*
* MULTI-FIXME:
* When we support multiple interfaces on different channels,
@@ -869,108 +985,7 @@ void iwl_chain_noise_calibration(struct iwl_priv *priv, void *stat_resp)
return;
/* Analyze signal for disconnected antenna */
- average_sig[0] = data->chain_signal_a /
- priv->cfg->base_params->chain_noise_num_beacons;
- average_sig[1] = data->chain_signal_b /
- priv->cfg->base_params->chain_noise_num_beacons;
- average_sig[2] = data->chain_signal_c /
- priv->cfg->base_params->chain_noise_num_beacons;
-
- if (average_sig[0] >= average_sig[1]) {
- max_average_sig = average_sig[0];
- max_average_sig_antenna_i = 0;
- active_chains = (1 << max_average_sig_antenna_i);
- } else {
- max_average_sig = average_sig[1];
- max_average_sig_antenna_i = 1;
- active_chains = (1 << max_average_sig_antenna_i);
- }
-
- if (average_sig[2] >= max_average_sig) {
- max_average_sig = average_sig[2];
- max_average_sig_antenna_i = 2;
- active_chains = (1 << max_average_sig_antenna_i);
- }
-
- IWL_DEBUG_CALIB(priv, "average_sig: a %d b %d c %d\n",
- average_sig[0], average_sig[1], average_sig[2]);
- IWL_DEBUG_CALIB(priv, "max_average_sig = %d, antenna %d\n",
- max_average_sig, max_average_sig_antenna_i);
-
- /* Compare signal strengths for all 3 receivers. */
- for (i = 0; i < NUM_RX_CHAINS; i++) {
- if (i != max_average_sig_antenna_i) {
- s32 rssi_delta = (max_average_sig - average_sig[i]);
-
- /* If signal is very weak, compared with
- * strongest, mark it as disconnected. */
- if (rssi_delta > MAXIMUM_ALLOWED_PATHLOSS)
- data->disconn_array[i] = 1;
- else
- active_chains |= (1 << i);
- IWL_DEBUG_CALIB(priv, "i = %d rssiDelta = %d "
- "disconn_array[i] = %d\n",
- i, rssi_delta, data->disconn_array[i]);
- }
- }
-
- /*
- * The above algorithm sometimes fails when the ucode
- * reports 0 for all chains. It's not clear why that
- * happens to start with, but it is then causing trouble
- * because this can make us enable more chains than the
- * hardware really has.
- *
- * To be safe, simply mask out any chains that we know
- * are not on the device.
- */
- if (priv->cfg->bt_params &&
- priv->cfg->bt_params->advanced_bt_coexist &&
- priv->bt_full_concurrent) {
- /* operated as 1x1 in full concurrency mode */
- active_chains &= first_antenna(priv->hw_params.valid_rx_ant);
- } else
- active_chains &= priv->hw_params.valid_rx_ant;
-
- num_tx_chains = 0;
- for (i = 0; i < NUM_RX_CHAINS; i++) {
- /* loops on all the bits of
- * priv->hw_setting.valid_tx_ant */
- u8 ant_msk = (1 << i);
- if (!(priv->hw_params.valid_tx_ant & ant_msk))
- continue;
-
- num_tx_chains++;
- if (data->disconn_array[i] == 0)
- /* there is a Tx antenna connected */
- break;
- if (num_tx_chains == priv->hw_params.tx_chains_num &&
- data->disconn_array[i]) {
- /*
- * If all chains are disconnected
- * connect the first valid tx chain
- */
- first_chain =
- find_first_chain(priv->cfg->valid_tx_ant);
- data->disconn_array[first_chain] = 0;
- active_chains |= BIT(first_chain);
- IWL_DEBUG_CALIB(priv, "All Tx chains are disconnected W/A - declare %d as connected\n",
- first_chain);
- break;
- }
- }
-
- if (active_chains != priv->hw_params.valid_rx_ant &&
- active_chains != priv->chain_noise_data.active_chains)
- IWL_DEBUG_CALIB(priv,
- "Detected that not all antennas are connected! "
- "Connected: %#x, valid: %#x.\n",
- active_chains, priv->hw_params.valid_rx_ant);
-
- /* Save for use within RXON, TX, SCAN commands, etc. */
- priv->chain_noise_data.active_chains = active_chains;
- IWL_DEBUG_CALIB(priv, "active_chains (bitwise) = 0x%x\n",
- active_chains);
+ iwl_find_disconn_antenna(priv, average_sig, data);
/* Analyze noise for rx balance */
average_noise[0] = data->chain_noise_a /