| Message ID | 1341732196-2869-1-git-send-email-rmanohar@qca.qualcomm.com (mailing list archive) |
|---|---|
| State | Not Applicable, archived |
| Headers | show |
diff --git a/drivers/net/wireless/ath/ath9k/reg.h b/drivers/net/wireless/ath/ath9k/reg.h index 22d2413..6592c07 100644 --- a/drivers/net/wireless/ath/ath9k/reg.h +++ b/drivers/net/wireless/ath/ath9k/reg.h @@ -2081,12 +2081,6 @@ enum { AR_MCI_INTERRUPT_RX_MSG_REMOTE_RESET| \ AR_MCI_INTERRUPT_RX_MSG_SYS_WAKING | \ AR_MCI_INTERRUPT_RX_MSG_SYS_SLEEPING| \ - AR_MCI_INTERRUPT_RX_MSG_SCHD_INFO | \ - AR_MCI_INTERRUPT_RX_MSG_LNA_CONTROL | \ - AR_MCI_INTERRUPT_RX_MSG_LNA_INFO | \ - AR_MCI_INTERRUPT_RX_MSG_CONT_NACK | \ - AR_MCI_INTERRUPT_RX_MSG_CONT_INFO | \ - AR_MCI_INTERRUPT_RX_MSG_CONT_RST | \ AR_MCI_INTERRUPT_RX_MSG_REQ_WAKE) #define AR_MCI_CPU_INT 0x1840
Remove the CONT_* and LNA_* messages from AR_MCI_INTERRUPT_RX_MSG_DEFAULT. Those MCI rx messages only meant for debugging purpose. Including them in default rx_msg series could raise huge amount of MCI interrupts when BT traffic is going on. And also it increases power consumption when WLAN is scanning. Signed-off-by: Rajkumar Manoharan <rmanohar@qca.qualcomm.com> --- drivers/net/wireless/ath/ath9k/reg.h | 6 ------ 1 file changed, 6 deletions(-)