@@ -512,16 +512,13 @@ irqreturn_t ath_isr(int irq, void *dev)
if (!ah || test_bit(ATH_OP_INVALID, &common->op_flags))
return IRQ_NONE;
- /* shared irq, not for us */
+ if (!AR_SREV_9100(ah) && test_bit(ATH_OP_HW_RESET, &common->op_flags))
+ return IRQ_NONE;
+ /* shared irq, not for us */
if (!ath9k_hw_intrpend(ah))
return IRQ_NONE;
- if (test_bit(ATH_OP_HW_RESET, &common->op_flags)) {
- ath9k_hw_kill_interrupts(ah);
- return IRQ_HANDLED;
- }
-
/*
* Figure out the reason(s) for the interrupt. Note
* that the hal returns a pseudo-ISR that may include
@@ -532,6 +529,9 @@ irqreturn_t ath_isr(int irq, void *dev)
ath9k_debug_sync_cause(sc, sync_cause);
status &= ah->imask; /* discard unasked-for bits */
+ if (AR_SREV_9100(ah) && test_bit(ATH_OP_HW_RESET, &common->op_flags))
+ return IRQ_HANDLED;
+
/*
* If there are no status bits set, then this interrupt was not
* for me (should have been caught above).
@@ -613,6 +613,7 @@ int ath_reset(struct ath_softc *sc, struct ath9k_channel *hchan)
struct ath_common *common = ath9k_hw_common(sc->sc_ah);
int r;
+ ath9k_hw_kill_interrupts(sc->sc_ah);
set_bit(ATH_OP_HW_RESET, &common->op_flags);
ath9k_ps_wakeup(sc);
@@ -633,6 +634,7 @@ void ath9k_queue_reset(struct ath_softc *sc, enum ath_reset_type type)
#ifdef CONFIG_ATH9K_DEBUGFS
RESET_STAT_INC(sc, type);
#endif
+ ath9k_hw_kill_interrupts(sc->sc_ah);
set_bit(ATH_OP_HW_RESET, &common->op_flags);
ieee80211_queue_work(sc->hw, &sc->hw_reset_work);
}
Instead of killing interrupts during reset when the first one happens, kill them before issuing the reset. This fixes an easy to reproduce crash with multiple cards sharing the same IRQ. Signed-off-by: Felix Fietkau <nbd@openwrt.org> --- drivers/net/wireless/ath/ath9k/main.c | 14 ++++++++------ 1 file changed, 8 insertions(+), 6 deletions(-)