diff mbox

[09/10] wil6210: store FW RF calibration result

Message ID 1501518753-6339-10-git-send-email-qca_merez@qca.qualcomm.com (mailing list archive)
State Superseded
Delegated to: Kalle Valo
Headers show

Commit Message

Maya Erez July 31, 2017, 4:32 p.m. UTC 
From: Dedy Lansky <qca_dlansky@qca.qualcomm.com>

Store initial FW RF calibration result in driver. Set this calibration
result back to FW after each FW reset in order to avoid future calibration
procedures.

Signed-off-by: Dedy Lansky <qca_dlansky@qca.qualcomm.com>
Signed-off-by: Maya Erez <qca_merez@qca.qualcomm.com>
---
 drivers/net/wireless/ath/wil6210/main.c    | 6 ++++++
 drivers/net/wireless/ath/wil6210/wil6210.h | 6 ++++++
 drivers/net/wireless/ath/wil6210/wmi.c     | 5 +++++
 drivers/net/wireless/ath/wil6210/wmi.h     | 2 ++
 4 files changed, 19 insertions(+)
diff mbox

Patch

diff --git a/drivers/net/wireless/ath/wil6210/main.c b/drivers/net/wireless/ath/wil6210/main.c
index b1e2814..b89d017 100644
--- a/drivers/net/wireless/ath/wil6210/main.c
+++ b/drivers/net/wireless/ath/wil6210/main.c
@@ -1034,6 +1034,12 @@  int wil_reset(struct wil6210_priv *wil, bool load_fw)
 		wil_s(wil, RGF_CAF_ICR + offsetof(struct RGF_ICR, ICR), 0);
 		wil_w(wil, RGF_CAF_ICR + offsetof(struct RGF_ICR, IMV), ~0);
 
+		if (wil->fw_calib_result > 0) {
+			__le32 val = cpu_to_le32(wil->fw_calib_result |
+						 (CALIB_RESULT_SIGNATURE << 8));
+			wil_w(wil, RGF_USER_FW_CALIB_RESULT, (u32 __force)val);
+		}
+
 		wil_release_cpu(wil);
 	}
 
diff --git a/drivers/net/wireless/ath/wil6210/wil6210.h b/drivers/net/wireless/ath/wil6210/wil6210.h
index f1488299..9ad7b11 100644
--- a/drivers/net/wireless/ath/wil6210/wil6210.h
+++ b/drivers/net/wireless/ath/wil6210/wil6210.h
@@ -171,6 +171,10 @@  struct RGF_ICR {
 #define RGF_USER_USER_SCRATCH_PAD	(0x8802bc)
 #define RGF_USER_BL			(0x880A3C) /* Boot Loader */
 #define RGF_USER_FW_REV_ID		(0x880a8c) /* chip revision */
+#define RGF_USER_FW_CALIB_RESULT	(0x880a90) /* b0-7:result
+						    * b8-15:signature
+						    */
+	#define CALIB_RESULT_SIGNATURE	(0x11)
 #define RGF_USER_CLKS_CTL_0		(0x880abc)
 	#define BIT_USER_CLKS_CAR_AHB_SW_SEL	BIT(1) /* ref clk/PLL */
 	#define BIT_USER_CLKS_RST_PWGD	BIT(11) /* reset on "power good" */
@@ -735,6 +739,8 @@  struct wil6210_priv {
 
 	enum wmi_ps_profile_type ps_profile;
 
+	int fw_calib_result;
+
 #ifdef CONFIG_PM
 #ifdef CONFIG_PM_SLEEP
 	struct notifier_block pm_notify;
diff --git a/drivers/net/wireless/ath/wil6210/wmi.c b/drivers/net/wireless/ath/wil6210/wmi.c
index a9487f2..ffdd2fa 100644
--- a/drivers/net/wireless/ath/wil6210/wmi.c
+++ b/drivers/net/wireless/ath/wil6210/wmi.c
@@ -344,6 +344,11 @@  static void wmi_evt_ready(struct wil6210_priv *wil, int id, void *d, int len)
 	strlcpy(wdev->wiphy->fw_version, wil->fw_version,
 		sizeof(wdev->wiphy->fw_version));
 
+	if (len > offsetof(struct wmi_ready_event, rfc_read_calib_result)) {
+		wil_dbg_wmi(wil, "rfc calibration result %d\n",
+			    evt->rfc_read_calib_result);
+		wil->fw_calib_result = evt->rfc_read_calib_result;
+	}
 	wil_set_recovery_state(wil, fw_recovery_idle);
 	set_bit(wil_status_fwready, wil->status);
 	/* let the reset sequence continue */
diff --git a/drivers/net/wireless/ath/wil6210/wmi.h b/drivers/net/wireless/ath/wil6210/wmi.h
index 4e31c2f..1b426d7 100644
--- a/drivers/net/wireless/ath/wil6210/wmi.h
+++ b/drivers/net/wireless/ath/wil6210/wmi.h
@@ -1300,6 +1300,8 @@  struct wmi_ready_event {
 	/* enum wmi_phy_capability */
 	u8 phy_capability;
 	u8 numof_additional_mids;
+	u8 rfc_read_calib_result;
+	u8 reserved[3];
 } __packed;
 
 /* WMI_NOTIFY_REQ_DONE_EVENTID */