| Message ID | 1544466691-11821-3-git-send-email-bperumal@codeaurora.org (mailing list archive) |
|---|---|
| State | Changes Requested |
| Delegated to: | Kalle Valo |
| Headers | show |
| Series | ath10k: Add support to configure BB timing for external FEM | expand |
On Tue, 11 Dec 2018 00:01:30 +0530, Bhagavathi Perumal S wrote: > This adds new dt entry ext-fem-name, it is used by ath10k driver > to select correct timing parameters and configure it in target wifi hardware. > The Front End Module(FEM) normally includes tx power amplifier(PA) and > rx low noise amplifier(LNA). The default timing parameters like tx end to > PA off timing values were fine tuned for internal FEM used in reference > design. And these timing values can not be same if ODM modifies hardware > design with different external FEM. This DT entry helps to choose correct > timing values in driver if different external FEM hardware used. > > Signed-off-by: Bhagavathi Perumal S <bperumal@codeaurora.org> > --- > Documentation/devicetree/bindings/net/wireless/qcom,ath10k.txt | 9 ++++++++- > 1 file changed, 8 insertions(+), 1 deletion(-) > Reviewed-by: Rob Herring <robh@kernel.org>
diff --git a/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.txt b/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.txt index ef60f25..71530fd 100644 --- a/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.txt +++ b/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.txt @@ -61,8 +61,14 @@ Optional properties: Value type: <phandle> Definition: reference to the reserved-memory for the msa region used by the wifi firmware running in Q6. +- ext-fem-name: + Usage: Optional + Value type: string + Definition: Name of external front end module used. Some valid FEM names + for example: "microsemi-lx5586", "sky85703-11" + and "sky85803" etc. -Example (to supply the calibration data alone): +Example (to supply PCI based wifi block details): In this example, the node is defined as child node of the PCI controller. @@ -77,6 +83,7 @@ pci { wifi@0,0 { reg = <0 0 0 0 0>; qcom,ath10k-calibration-data = [ 01 02 03 ... ]; + ext-fem-name = "microsemi-lx5586"; }; }; };
This adds new dt entry ext-fem-name, it is used by ath10k driver to select correct timing parameters and configure it in target wifi hardware. The Front End Module(FEM) normally includes tx power amplifier(PA) and rx low noise amplifier(LNA). The default timing parameters like tx end to PA off timing values were fine tuned for internal FEM used in reference design. And these timing values can not be same if ODM modifies hardware design with different external FEM. This DT entry helps to choose correct timing values in driver if different external FEM hardware used. Signed-off-by: Bhagavathi Perumal S <bperumal@codeaurora.org> --- Documentation/devicetree/bindings/net/wireless/qcom,ath10k.txt | 9 ++++++++- 1 file changed, 8 insertions(+), 1 deletion(-)