diff mbox series

[4/4] ath10k: don't report unset rssi values to mac80211

Message ID 1550766118-31703-5-git-send-email-kvalo@codeaurora.org (mailing list archive)
State Accepted
Commit 7d444522303177f3a3c09b9abb104ddeea470a70
Delegated to: Kalle Valo
Headers show
Series ath10k: small fixes for SDIO support | expand

Commit Message

Kalle Valo Feb. 21, 2019, 4:21 p.m. UTC 
From: Alagu Sankar <alagusankar@silex-india.com>

The SDIO firmware does not provide RSSI value to the host, it's only set to
zero. In that case don't report the value to mac80211. One risk here is that
value zero might be a valid value with other firmware, currently there's no way
to detect that.

Without the fix, the rssi value indicated by iw changes between the actual
value and -95.

Tested with QCA6174 SDIO with firmware WLAN.RMH.4.4.1-00005-QCARMSWP-1.

Co-developed-by: Wen Gong <wgong@codeaurora.org>
Signed-off-by: Alagu Sankar <alagusankar@silex-india.com>
Signed-off-by: Wen Gong <wgong@codeaurora.org>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>
---
 drivers/net/wireless/ath/ath10k/htt_rx.c | 12 +++++++++---
 1 file changed, 9 insertions(+), 3 deletions(-)
diff mbox series

Patch

diff --git a/drivers/net/wireless/ath/ath10k/htt_rx.c b/drivers/net/wireless/ath/ath10k/htt_rx.c
index 4fc885617de1..62479b037210 100644
--- a/drivers/net/wireless/ath/ath10k/htt_rx.c
+++ b/drivers/net/wireless/ath/ath10k/htt_rx.c
@@ -2119,9 +2119,15 @@  static bool ath10k_htt_rx_proc_rx_ind_hl(struct ath10k_htt *htt,
 	hdr = (struct ieee80211_hdr *)skb->data;
 	rx_status = IEEE80211_SKB_RXCB(skb);
 	rx_status->chains |= BIT(0);
-	rx_status->signal = ATH10K_DEFAULT_NOISE_FLOOR +
-			    rx->ppdu.combined_rssi;
-	rx_status->flag &= ~RX_FLAG_NO_SIGNAL_VAL;
+	if (rx->ppdu.combined_rssi == 0) {
+		/* SDIO firmware does not provide signal */
+		rx_status->signal = 0;
+		rx_status->flag |= RX_FLAG_NO_SIGNAL_VAL;
+	} else {
+		rx_status->signal = ATH10K_DEFAULT_NOISE_FLOOR +
+			rx->ppdu.combined_rssi;
+		rx_status->flag &= ~RX_FLAG_NO_SIGNAL_VAL;
+	}
 
 	spin_lock_bh(&ar->data_lock);
 	ch = ar->scan_channel;