@@ -2681,6 +2681,13 @@ static void ath11k_bss_assoc(struct ieee80211_hw *hw,
if (ret)
ath11k_warn(ar->ab, "failed to set vdev %i OBSS PD parameters: %d\n",
arvif->vdev_id, ret);
+
+ ret = ath11k_wmi_vdev_set_param_cmd(ar, arvif->vdev_id,
+ WMI_VDEV_PARAM_DTIM_POLICY,
+ WMI_DTIM_POLICY_STICK);
+ if (ret)
+ ath11k_warn(ar->ab, "failed to set vdev %d dtim policy: %d\n",
+ arvif->vdev_id, ret);
}
static void ath11k_bss_disassoc(struct ieee80211_hw *hw,
@@ -2169,6 +2169,13 @@ enum wmi_nss_ratio {
WMI_NSS_RATIO_2_NSS = 0x3,
};
+enum wmi_dtim_policy {
+ WMI_DTIM_POLICY_IGNORE = 1,
+ WMI_DTIM_POLICY_NORMAL = 2,
+ WMI_DTIM_POLICY_STICK = 3,
+ WMI_DTIM_POLICY_AUTO = 4,
+};
+
struct wmi_host_pdev_band_to_mac {
u32 pdev_id;
u32 start_freq;
Set DTIM policy to DTIM stick mode, so station follows AP DTIM interval rather than listen interval which is set in peer assoc cmd. DTIM stick mode is more preferred per firmware team request. Tested-on: QCA6390 hw2.0 PCI WLAN.HST.1.0.1-01740-QCAHSTSWPLZ_V2_TO_X86-1 Signed-off-by: Carl Huang <quic_cjhuang@quicinc.org> --- v2: - rebased on top of 4f4f8aee394b73abf5e5f98c63187fdbf1d627f0 drivers/net/wireless/ath/ath11k/mac.c | 7 +++++++ drivers/net/wireless/ath/ath11k/wmi.h | 7 +++++++ 2 files changed, 14 insertions(+) base-commit: 4f4f8aee394b73abf5e5f98c63187fdbf1d627f0