@@ -502,6 +502,10 @@ struct ieee80211_mu_group_data {
* implies disabled. As with the cfg80211 callback, a change here should
* cause an event to be sent indicating where the current value is in
* relation to the newly configured threshold.
+ * @cqm_rssi_low: Connection quality monitor RSSI lower threshold, a zero value
+ * implies disabled. This is an alternative mechanism to the single
+ * threshold event and can't be enabled simultaneously with it.
+ * @cqm_rssi_high: Connection quality monitor RSSI upper threshold.
* @cqm_rssi_hyst: Connection quality monitor RSSI hysteresis
* @arp_addr_list: List of IPv4 addresses for hardware ARP filtering. The
* may filter ARP queries targeted for other addresses than listed here.
@@ -554,6 +558,8 @@ struct ieee80211_bss_conf {
u16 ht_operation_mode;
s32 cqm_rssi_thold;
u32 cqm_rssi_hyst;
+ s32 cqm_rssi_low;
+ s32 cqm_rssi_high;
struct cfg80211_chan_def chandef;
struct ieee80211_mu_group_data mu_group;
__be32 arp_addr_list[IEEE80211_BSS_ARP_ADDR_LIST_LEN];
@@ -2630,6 +2630,33 @@ static int ieee80211_set_cqm_rssi_config(struct wiphy *wiphy,
bss_conf->cqm_rssi_thold = rssi_thold;
bss_conf->cqm_rssi_hyst = rssi_hyst;
+ bss_conf->cqm_rssi_low = 0;
+ bss_conf->cqm_rssi_high = 0;
+ sdata->u.mgd.last_cqm_event_signal = 0;
+
+ /* tell the driver upon association, unless already associated */
+ if (sdata->u.mgd.associated &&
+ sdata->vif.driver_flags & IEEE80211_VIF_SUPPORTS_CQM_RSSI)
+ ieee80211_bss_info_change_notify(sdata, BSS_CHANGED_CQM);
+
+ return 0;
+}
+
+static int ieee80211_set_cqm_rssi_range_config(struct wiphy *wiphy,
+ struct net_device *dev,
+ s32 rssi_low, s32 rssi_high)
+{
+ struct ieee80211_sub_if_data *sdata = IEEE80211_DEV_TO_SUB_IF(dev);
+ struct ieee80211_vif *vif = &sdata->vif;
+ struct ieee80211_bss_conf *bss_conf = &vif->bss_conf;
+
+ if (sdata->vif.driver_flags & IEEE80211_VIF_BEACON_FILTER)
+ return -EOPNOTSUPP;
+
+ bss_conf->cqm_rssi_low = rssi_low;
+ bss_conf->cqm_rssi_high = rssi_high;
+ bss_conf->cqm_rssi_thold = 0;
+ bss_conf->cqm_rssi_hyst = 0;
sdata->u.mgd.last_cqm_event_signal = 0;
/* tell the driver upon association, unless already associated */
@@ -3628,6 +3655,7 @@ const struct cfg80211_ops mac80211_config_ops = {
.mgmt_tx = ieee80211_mgmt_tx,
.mgmt_tx_cancel_wait = ieee80211_mgmt_tx_cancel_wait,
.set_cqm_rssi_config = ieee80211_set_cqm_rssi_config,
+ .set_cqm_rssi_range_config = ieee80211_set_cqm_rssi_range_config,
.mgmt_frame_register = ieee80211_mgmt_frame_register,
.set_antenna = ieee80211_set_antenna,
.get_antenna = ieee80211_get_antenna,
@@ -3434,6 +3434,30 @@ static void ieee80211_rx_mgmt_beacon(struct ieee80211_sub_if_data *sdata,
}
}
+ if (bss_conf->cqm_rssi_low &&
+ ifmgd->count_beacon_signal >= IEEE80211_SIGNAL_AVE_MIN_COUNT) {
+ int sig = -ewma_beacon_signal_read(&ifmgd->ave_beacon_signal);
+ int last_event = ifmgd->last_cqm_event_signal;
+ int low = bss_conf->cqm_rssi_low;
+ int high = bss_conf->cqm_rssi_high;
+
+ if (sig < low &&
+ (last_event == 0 || last_event >= low)) {
+ ifmgd->last_cqm_event_signal = sig;
+ ieee80211_cqm_rssi_notify(
+ &sdata->vif,
+ NL80211_CQM_RSSI_THRESHOLD_EVENT_LOW,
+ sig, GFP_KERNEL);
+ } else if (sig > high &&
+ (last_event == 0 || last_event <= high)) {
+ ifmgd->last_cqm_event_signal = sig;
+ ieee80211_cqm_rssi_notify(
+ &sdata->vif,
+ NL80211_CQM_RSSI_THRESHOLD_EVENT_HIGH,
+ sig, GFP_KERNEL);
+ }
+ }
+
if (ifmgd->flags & IEEE80211_STA_CONNECTION_POLL) {
mlme_dbg_ratelimited(sdata,
"cancelling AP probe due to a received beacon\n");
Support .set_cqm_rssi_range_config if the beacons are available for processing in mac80211. There's no reason that this couldn't be offloaded by mac80211-based drivers but there's no driver method for that added in this patch as I don't have the hardware. Signed-off-by: Andrew Zaborowski <andrew.zaborowski@intel.com> --- changes in v3: - set NL80211_EXT_FEATURE_CQM_RSSI_LIST automatically in ieee80211_register_hw based on the default interface's IEEE80211_VIF_BEACON_FILTER flag. changes in v4: - drop the above attempt and set NL80211_EXT_FEATURE_CQM_RSSI_LIST in a separate patch in each driver. --- include/net/mac80211.h | 6 ++++++ net/mac80211/cfg.c | 28 ++++++++++++++++++++++++++++ net/mac80211/mlme.c | 24 ++++++++++++++++++++++++ 3 files changed, 58 insertions(+)