@@ -61,8 +61,6 @@
#define ST21NFCA_HCI_DRIVER_NAME "st21nfca_hci"
#define ST21NFCA_HCI_I2C_DRIVER_NAME "st21nfca_hci_i2c"
-#define ST21NFCA_GPIO_NAME_EN "enable"
-
struct st21nfca_i2c_phy {
struct i2c_client *i2c_dev;
struct nfc_hci_dev *hdev;
@@ -508,44 +506,10 @@ static const struct acpi_gpio_mapping acpi_st21nfca_gpios[] = {
{},
};
-static int st21nfca_hci_i2c_acpi_request_resources(struct i2c_client *client)
-{
- struct st21nfca_i2c_phy *phy = i2c_get_clientdata(client);
- struct device *dev = &client->dev;
- int ret;
-
- ret = devm_acpi_dev_add_driver_gpios(dev, acpi_st21nfca_gpios);
- if (ret)
- return ret;
-
- /* Get EN GPIO from ACPI */
- phy->gpiod_ena = devm_gpiod_get(dev, ST21NFCA_GPIO_NAME_EN, GPIOD_OUT_LOW);
- if (IS_ERR(phy->gpiod_ena)) {
- nfc_err(dev, "Unable to get ENABLE GPIO\n");
- return PTR_ERR(phy->gpiod_ena);
- }
-
- return 0;
-}
-
-static int st21nfca_hci_i2c_of_request_resources(struct i2c_client *client)
-{
- struct st21nfca_i2c_phy *phy = i2c_get_clientdata(client);
- struct device *dev = &client->dev;
-
- /* Get GPIO from device tree */
- phy->gpiod_ena = devm_gpiod_get(dev, ST21NFCA_GPIO_NAME_EN, GPIOD_OUT_HIGH);
- if (IS_ERR(phy->gpiod_ena)) {
- nfc_err(dev, "Failed to request enable pin\n");
- return PTR_ERR(phy->gpiod_ena);
- }
-
- return 0;
-}
-
static int st21nfca_hci_i2c_probe(struct i2c_client *client,
const struct i2c_device_id *id)
{
+ struct device *dev = &client->dev;
struct st21nfca_i2c_phy *phy;
int r;
@@ -572,21 +536,15 @@ static int st21nfca_hci_i2c_probe(struct i2c_client *client,
mutex_init(&phy->phy_lock);
i2c_set_clientdata(client, phy);
- if (client->dev.of_node) {
- r = st21nfca_hci_i2c_of_request_resources(client);
- if (r) {
- nfc_err(&client->dev, "No platform data\n");
- return r;
- }
- } else if (ACPI_HANDLE(&client->dev)) {
- r = st21nfca_hci_i2c_acpi_request_resources(client);
- if (r) {
- nfc_err(&client->dev, "Cannot get ACPI data\n");
- return r;
- }
- } else {
- nfc_err(&client->dev, "st21nfca platform resources not available\n");
- return -ENODEV;
+ r = devm_acpi_dev_add_driver_gpios(dev, acpi_st21nfca_gpios);
+ if (r)
+ dev_dbg(dev, "Unable to add GPIO mapping table\n");
+
+ /* Get EN GPIO from resource provider */
+ phy->gpiod_ena = devm_gpiod_get(dev, "enable", GPIOD_OUT_LOW);
+ if (IS_ERR(phy->gpiod_ena)) {
+ nfc_err(dev, "Unable to get ENABLE GPIO\n");
+ return PTR_ERR(phy->gpiod_ena);
}
phy->se_status.is_ese_present =
Since OF and ACPI case almost the same get rid of code duplication by moving gpiod_get() calls directly to ->probe(). Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com> --- drivers/nfc/st21nfca/i2c.c | 62 ++++++++-------------------------------------- 1 file changed, 10 insertions(+), 52 deletions(-)