@@ -2506,6 +2506,19 @@ void ieee80211_free_txskb(struct ieee80211_hw *hw, struct sk_buff *skb);
* The set_default_unicast_key() call updates the default WEP key index
* configured to the hardware for WEP encryption type. This is required
* for devices that support offload of data packets (e.g. ARP responses).
+ *
+ * Mac80211 drivers should set the @NL80211_EXT_FEATURE_CAN_REPLACE_PTK0 flag
+ * when they are able to replace in-use PTK keys according to to following
+ * requirements:
+ * 1) They do not hand over frames decrypted with the old key to
+ mac80211 once the call to set_key() with command %DISABLE_KEY has been
+ completed when also setting @IEEE80211_KEY_FLAG_GENERATE_IV for any key
+ 2) either drop or continue to use the old key for any outgoing frames queued
+ at the time of the key deletion (especially re-transmits),
+ 3) never send out a frame queued prior to the set_key() %SET_KEY command
+ encrypted with the new key and
+ 4) never send out a frame unencrypted when it should be encrypted.
+ Mac80211 will not queue any new frames for a deleted key to the driver.
*/
/**
@@ -248,6 +248,7 @@ static void ieee80211_key_disable_hw_accel(struct ieee80211_key *key)
(key->conf.flags & IEEE80211_KEY_FLAG_RESERVE_TAILROOM)))
increment_tailroom_need_count(sdata);
+ key->flags &= ~KEY_FLAG_UPLOADED_TO_HARDWARE;
ret = drv_set_key(key->local, DISABLE_KEY, sdata,
sta ? &sta->sta : NULL, &key->conf);
@@ -256,8 +257,73 @@ static void ieee80211_key_disable_hw_accel(struct ieee80211_key *key)
"failed to remove key (%d, %pM) from hardware (%d)\n",
key->conf.keyidx,
sta ? sta->sta.addr : bcast_addr, ret);
+}
- key->flags &= ~KEY_FLAG_UPLOADED_TO_HARDWARE;
+static int ieee80211_hw_key_replace(struct ieee80211_key *old_key,
+ struct ieee80211_key *new_key,
+ bool ptk0rekey)
+{
+ struct ieee80211_sub_if_data *sdata;
+ struct ieee80211_local *local;
+ struct sta_info *sta;
+ int ret;
+
+ /* Aggregation sessions are ok when running on SW crypto.
+ * A broken remote STA may cause issues not observed with HW
+ * crypto, though.
+ */
+ if (!(old_key->flags & KEY_FLAG_UPLOADED_TO_HARDWARE))
+ return 0;
+
+ assert_key_lock(old_key->local);
+ sta = old_key->sta;
+
+ /* PTK only using key ID 0 needs special handling on rekey */
+ if (new_key && sta && ptk0rekey) {
+ local = old_key->local;
+ sdata = old_key->sdata;
+
+ /* Stop TX till we are on the new key */
+ old_key->flags |= KEY_FLAG_TAINTED;
+ ieee80211_clear_fast_xmit(sta);
+
+ /* Aggregation sessions during rekey are complicated due to
+ * the reorder buffer. Side step that by blocking aggregation
+ * and tear down running connections.
+ */
+ if (ieee80211_hw_check(&local->hw, AMPDU_AGGREGATION)) {
+ set_sta_flag(sta, WLAN_STA_BLOCK_BA);
+ ieee80211_sta_tear_down_BA_sessions(sta,
+ AGG_STOP_LOCAL_REQUEST);
+ }
+
+ if (!wiphy_ext_feature_isset(new_key->local->hw.wiphy,
+ NL80211_EXT_FEATURE_CAN_REPLACE_PTK0)) {
+ pr_warn_ratelimited("Userspace is rekeying PTK for " \
+ "STA %pM with a driver not " \
+ "setting NL80211_EXT_FEATURE_" \
+ "CAN_REPLACE_PTK0. This may leak " \
+ "clear text packets or randomly " \
+ "freeze the connection.",
+ sta->sta.addr);
+ /* Flushing the driver queues *may* help prevent
+ * the cleartext leaks and freezes.
+ */
+ ieee80211_flush_queues(old_key->local,
+ old_key->sdata,
+ false);
+ }
+ ieee80211_key_disable_hw_accel(old_key);
+ ret = ieee80211_key_enable_hw_accel(new_key);
+ } else {
+ ieee80211_key_disable_hw_accel(old_key);
+ if (new_key)
+ ret = ieee80211_key_enable_hw_accel(new_key);
+ else
+ ret = 0;
+ }
+
+ return ret;
}
static void __ieee80211_set_default_key(struct ieee80211_sub_if_data *sdata,
@@ -316,38 +382,56 @@ void ieee80211_set_default_mgmt_key(struct ieee80211_sub_if_data *sdata,
}
-static void ieee80211_key_replace(struct ieee80211_sub_if_data *sdata,
+static int ieee80211_key_replace(struct ieee80211_sub_if_data *sdata,
struct sta_info *sta,
bool pairwise,
struct ieee80211_key *old,
struct ieee80211_key *new)
{
int idx;
+ int ret;
bool defunikey, defmultikey, defmgmtkey;
/* caller must provide at least one old/new */
if (WARN_ON(!new && !old))
- return;
+ return 0;
if (new)
list_add_tail_rcu(&new->list, &sdata->key_list);
WARN_ON(new && old && new->conf.keyidx != old->conf.keyidx);
- if (old)
+ if (old) {
idx = old->conf.keyidx;
- else
+ /* TODO: proper implement and test "Extended Key ID for
+ * Individually Addressed Frames" from IEEE 802.11-2016.
+ * Till then always assume only key ID 0 is used for
+ * pairwise keys.*/
+ ret = ieee80211_hw_key_replace(old, new, pairwise);
+ } else {
idx = new->conf.keyidx;
+ if (new && !new->local->wowlan)
+ ret = ieee80211_key_enable_hw_accel(new);
+ else
+ ret = 0;
+ }
+
+ if (ret)
+ return ret;
if (sta) {
if (pairwise) {
rcu_assign_pointer(sta->ptk[idx], new);
sta->ptk_idx = idx;
- ieee80211_check_fast_xmit(sta);
+ if (new) {
+ clear_sta_flag(sta, WLAN_STA_BLOCK_BA);
+ ieee80211_check_fast_xmit(sta);
+ }
} else {
rcu_assign_pointer(sta->gtk[idx], new);
}
- ieee80211_check_fast_rx(sta);
+ if (new)
+ ieee80211_check_fast_rx(sta);
} else {
defunikey = old &&
old == key_mtx_dereference(sdata->local,
@@ -380,6 +464,8 @@ static void ieee80211_key_replace(struct ieee80211_sub_if_data *sdata,
if (old)
list_del_rcu(&old->list);
+
+ return 0;
}
struct ieee80211_key *
@@ -575,9 +661,6 @@ static void ieee80211_key_free_common(struct ieee80211_key *key)
static void __ieee80211_key_destroy(struct ieee80211_key *key,
bool delay_tailroom)
{
- if (key->local)
- ieee80211_key_disable_hw_accel(key);
-
if (key->local) {
struct ieee80211_sub_if_data *sdata = key->sdata;
@@ -654,7 +737,6 @@ int ieee80211_key_link(struct ieee80211_key *key,
struct ieee80211_sub_if_data *sdata,
struct sta_info *sta)
{
- struct ieee80211_local *local = sdata->local;
struct ieee80211_key *old_key;
int idx = key->conf.keyidx;
bool pairwise = key->conf.flags & IEEE80211_KEY_FLAG_PAIRWISE;
@@ -691,17 +773,13 @@ int ieee80211_key_link(struct ieee80211_key *key,
increment_tailroom_need_count(sdata);
- ieee80211_key_replace(sdata, sta, pairwise, old_key, key);
- ieee80211_key_destroy(old_key, delay_tailroom);
-
- ieee80211_debugfs_key_add(key);
+ ret = ieee80211_key_replace(sdata, sta, pairwise, old_key, key);
- if (!local->wowlan) {
- ret = ieee80211_key_enable_hw_accel(key);
- if (ret)
- ieee80211_key_free(key, delay_tailroom);
+ if (!ret) {
+ ieee80211_debugfs_key_add(key);
+ ieee80211_key_destroy(old_key, delay_tailroom);
} else {
- ret = 0;
+ ieee80211_key_free(key, delay_tailroom);
}
out:
@@ -2951,6 +2951,10 @@ void ieee80211_check_fast_xmit(struct sta_info *sta)
if (!(build.key->flags & KEY_FLAG_UPLOADED_TO_HARDWARE))
goto out;
+ /* Key is being removed */
+ if (build.key->flags & KEY_FLAG_TAINTED)
+ goto out;
+
switch (build.key->conf.cipher) {
case WLAN_CIPHER_SUITE_CCMP:
case WLAN_CIPHER_SUITE_CCMP_256:
Rekeying PTK keys without "Extended Key ID for Individually Addressed Frames" did use a procedure not suitable to replace in-use keys and could caused the following issues: 1) Freeze caused by incoming frames: If the local STA installed the key prior to the remote STA we still had the old key active in the hardware when mac80211 switched over to the new key. Therefore there was a window where the card could hand over frames decoded with the old key to mac80211 and bump the new PN (IV) value to an incorrect high number. When it happened the local replay detection silently started to drop all frames sent with the new key. 2) Freeze caused by outgoing frames: If mac80211 was providing the PN (IV) and handed over a clear text frame for encryption to the hardware prior to a key change the driver/card could have processed the queued frame after switching to the new key. This bumped the PN value on the remote STA to an incorrect high number, tricking the remote STA to discard all frames we sent later. 3) Freeze caused by RX aggregation reorder buffer: An aggregation session started with the old key and ending after the switch to the new key also bumped the PN to an incorrect high number, freezing the connection quite similar to 1). 4) Freeze caused by repeating lost frames in an aggregation session: A driver could repeat a lost frame and encrypt it with the new key while in a TX aggregation session without updating the PN for the new key. This also could freeze connections similar to 2). 5) Clear text leak: Removing encryption offload from the card cleared the encryption offload flag only after the card had deleted the key and we did not stop TX during the rekey. The driver/card could therefore get unencrypted frames from mac80211 while no longer be instructed to encrypt them. To prevent those issues the key install logic has been changed: - We now flag drivers known to be able to rekey PTK0 keys with NL80211_EXT_FEATURE_CAN_REPLACE_PTK0, - stop queuing frames depending on the key while replacing it - replace the key first in the hardware and only after that in mac80211 - and stop/block new aggregation sessions during the rekey. For drivers not setting NL80211_EXT_FEATURE_CAN_REPLACE_PTK0 the user space must avoid PTK rekeys if "Extended Key ID for Individually Addressed Frames" is not being used. Rekeys for mac80211 drivers without this flag will generate a warning and use an extra call to ieee80211_flush_queues() to both highlight and try to prevent the issues with not updated drivers. The core of the fix changes the key install procedure from: - atomic switch over to the new key in mac80211 - remove the old key in the hardware (stops encryption offloading, fall back to software encryption with a potential clear text packet leak in between) - delete the inactive old key in mac80211 - enable hardware encryption offloading for the new key to: - if it's a PTK mark the old key as tainted to drop TX frames with the outgoing key - replace the key in hardware with the new one - atomic switch over to the new (not marked as tainted) key in mac80211 (which also resumes TX) - delete the inactive old key in mac80211 With the new sequence the hardware will be unable to decrypt frames encrypted with the old key prior to switching to the new key in mac80211 and thus prevent PNs from packets decrypted with the old key to be accounted against the new key. For that to work the drivers have to provide a clear boundary. Mac80211 drivers setting @NL80211_EXT_FEATURE_CAN_REPLACE_PTK0 confirm to provide it and mac80211 will then be able to correctly rekey in-use PTK keys with those drivers. The mac80211 requirements for drivers to set the flag have been added to the "Hardware crypto acceleration" documentation section. It drills down to: The drivers must not hand over frames decrypted with the old key to mac80211 once the call to set_key() with %DISABLE_KEY has been completed. It's allowed to either drop or continue to use the old key for any outgoing frames which are already in the queues, but it must not send out any of them unencrypted or encrypted with the new key. Even with the new boundary in place aggregation sessions with the reorder buffer are a problem: RX aggregation session started prior and completed after the rekey could still dump frames received with the old key at mac80211 after it switched over to the new key. This is side stepped by stopping all (RX and TX) aggregation sessions when replacing a PTK key and hardware key offloading. Stopping TX aggregation sessions avoids the need to get the PNs (IVs) updated in frames prepared for the old key and (re)transmitted after the switch to the new key. As a bonus it improves the compatibility when the remote STA is not handling rekeys as it should. When using software crypto aggregation sessions are not stopped. Mac80211 won't be able to decode the dangerous frames and discard them without special handling. Signed-off-by: Alexander Wetzel <alexander@wetzel-home.de> --- include/net/mac80211.h | 13 +++++ net/mac80211/key.c | 118 ++++++++++++++++++++++++++++++++++------- net/mac80211/tx.c | 4 ++ 3 files changed, 115 insertions(+), 20 deletions(-)