@@ -1413,6 +1413,76 @@ struct wcn36xx_hal_config_sta_req_msg {
struct wcn36xx_hal_config_sta_params sta_params;
} __packed;
+struct wcn36xx_hal_supported_rates_v1 {
+ /* For Self STA Entry: this represents Self Mode.
+ * For Peer Stations, this represents the mode of the peer.
+ * On Station:
+ *
+ * --this mode is updated when PE adds the Self Entry.
+ *
+ * -- OR when PE sends 'ADD_BSS' message and station context in BSS
+ * is used to indicate the mode of the AP.
+ *
+ * ON AP:
+ *
+ * -- this mode is updated when PE sends 'ADD_BSS' and Sta entry
+ * for that BSS is used to indicate the self mode of the AP.
+ *
+ * -- OR when a station is associated, PE sends 'ADD_STA' message
+ * with this mode updated.
+ */
+
+ enum sta_rate_mode op_rate_mode;
+
+ /* 11b, 11a and aniLegacyRates are IE rates which gives rate in
+ * unit of 500Kbps
+ */
+ u16 dsss_rates[WCN36XX_HAL_NUM_DSSS_RATES];
+ u16 ofdm_rates[WCN36XX_HAL_NUM_OFDM_RATES];
+ u16 legacy_rates[WCN36XX_HAL_NUM_POLARIS_RATES];
+ u16 reserved;
+
+ /* Taurus only supports 26 Titan Rates(no ESF/concat Rates will be
+ * supported) First 26 bits are reserved for those Titan rates and
+ * the last 4 bits(bit28-31) for Taurus, 2(bit26-27) bits are
+ * reserved
+ * Titan and Taurus Rates
+ */
+ u32 enhanced_rate_bitmap;
+
+ /* 0-76 bits used, remaining reserved
+ * bits 0-15 and 32 should be set.
+ */
+ u8 supported_mcs_set[WCN36XX_HAL_MAC_MAX_SUPPORTED_MCS_SET];
+
+ /* RX Highest Supported Data Rate defines the highest data
+ * rate that the STA is able to receive, in unites of 1Mbps.
+ * This value is derived from "Supported MCS Set field" inside
+ * the HT capability element.
+ */
+ u16 rx_highest_data_rate;
+
+ /* Indicates the Maximum MCS that can be received for each spatial
+ * stream.
+ */
+ u16 vht_rx_mcs_map;
+
+ /* Indicates the highest VHT data rate that the STA is able to
+ * receive.
+ */
+ u16 vht_rx_highest_data_rate;
+
+ /* Indicates the Maximum MCS that can be transmitted for each spatial
+ * stream.
+ */
+ u16 vht_tx_mcs_map;
+
+ /* Indicates the highest VHT data rate that the STA is able to
+ * transmit.
+ */
+ u16 vht_tx_highest_data_rate;
+} __packed;
+
struct wcn36xx_hal_config_sta_params_v1 {
/* BSSID of STA */
u8 bssid[ETH_ALEN];
This commit adds the supported rates V1 structure as defined in Prima riva/inc/wlan_hal_msg.h Signed-off-by: Bryan O'Donoghue <bryan.odonoghue@linaro.org> --- drivers/net/wireless/ath/wcn36xx/hal.h | 70 ++++++++++++++++++++++++++ 1 file changed, 70 insertions(+)