@@ -1948,9 +1948,25 @@ static void ath11k_mac_op_bss_info_changed(struct ieee80211_hw *hw,
if (changed & BSS_CHANGED_BSSID && !is_zero_ether_addr(info->bssid))
ether_addr_copy(arvif->bssid, info->bssid);
- if (changed & BSS_CHANGED_BEACON_ENABLED)
+ if (changed & BSS_CHANGED_BEACON_ENABLED) {
ath11k_control_beaconing(arvif, info);
+ if (arvif->is_up && vif->bss_conf.he_support &&
+ vif->bss_conf.he_oper.params) {
+ param_id = WMI_VDEV_PARAM_HEOPS_0_31;
+ param_value = vif->bss_conf.he_oper.params;
+ ret = ath11k_wmi_vdev_set_param_cmd(ar, arvif->vdev_id,
+ param_id, param_value);
+ ath11k_dbg(ar->ab, ATH11K_DBG_MAC,
+ "he oper param: %x set for VDEV: %d\n",
+ param_value, arvif->vdev_id);
+
+ if (ret)
+ ath11k_warn(ar->ab, "Failed to set he oper params %x for VDEV %d: %i\n",
+ param_value, arvif->vdev_id, ret);
+ }
+ }
+
if (changed & BSS_CHANGED_ERP_CTS_PROT) {
u32 cts_prot;
HE operation IE in beacons is constructed based on userspace params, which firmware might not be aware of. This causes firmware not to configure TXOP duration based RTS threshold which could cause mismatch in behaviour with respect to what is being advertised in beacons. This patch sends HE operation IE fetched from beacon to firmware using WMI interface for configuration. Tested-on: IPQ8074 hw2.0 AHB WLAN.HK.2.1.0.1-01228-QCAHKSWPL_SILICONZ-1 Signed-off-by: Pradeep Kumar Chitrapu <pradeepc@codeaurora.org> --- drivers/net/wireless/ath/ath11k/mac.c | 18 +++++++++++++++++- 1 file changed, 17 insertions(+), 1 deletion(-)