diff mbox series

[v4,1/2] mac80211: Add support to trigger sta disconnect on hardware restart

Message ID 20220303115541.15892-2-youghand@codeaurora.org (mailing list archive)
State Superseded
Delegated to: Johannes Berg
Headers show
Series mac80211: Trigger disconnect for STA during target hardware restart | expand

Commit Message

Youghandhar Chintala March 3, 2022, 11:55 a.m. UTC
Currently in case of target hardware restart, we just reconfig and
re-enable the security keys and enable the network queues to start
data traffic back from where it was interrupted.

Many ath10k wifi chipsets have sequence numbers for the data
packets assigned by firmware and the mac sequence number will
restart from zero after target hardware restart leading to mismatch
in the sequence number expected by the remote peer vs the sequence
number of the frame sent by the target firmware.

This mismatch in sequence number will cause out-of-order packets
on the remote peer and all the frames sent by the device are dropped
until we reach the sequence number which was sent before we restarted
the target hardware

In order to fix this, we trigger a sta disconnect, in case of target
hw restart. After this there will be a fresh connection and thereby
avoiding the dropping of frames by remote peer.

The right fix would be to pull the entire data path into the host
which is not feasible or would need lots of complex changes and
will still be inefficient.

Tested on ath10k using WCN3990, QCA6174

Signed-off-by: Youghandhar Chintala <youghand@codeaurora.org>
---
 include/net/mac80211.h     | 11 +++++++++++
 net/mac80211/ieee80211_i.h |  3 +++
 net/mac80211/mlme.c        | 12 ++++++++++++
 net/mac80211/util.c        | 33 ++++++++++++++++++++++++++++++---
 4 files changed, 56 insertions(+), 3 deletions(-)

Comments

Jeff Johnson March 3, 2022, 4:44 p.m. UTC | #1
On 3/3/2022 3:55 AM, Youghandhar Chintala wrote:
> Currently in case of target hardware restart, we just reconfig and
> re-enable the security keys and enable the network queues to start
> data traffic back from where it was interrupted.
> 
> Many ath10k wifi chipsets have sequence numbers for the data
> packets assigned by firmware and the mac sequence number will
> restart from zero after target hardware restart leading to mismatch
> in the sequence number expected by the remote peer vs the sequence
> number of the frame sent by the target firmware.
> 
> This mismatch in sequence number will cause out-of-order packets
> on the remote peer and all the frames sent by the device are dropped
> until we reach the sequence number which was sent before we restarted
> the target hardware
> 
> In order to fix this, we trigger a sta disconnect, in case of target
> hw restart. After this there will be a fresh connection and thereby
> avoiding the dropping of frames by remote peer.
> 
> The right fix would be to pull the entire data path into the host
> which is not feasible or would need lots of complex changes and
> will still be inefficient.
> 
> Tested on ath10k using WCN3990, QCA6174
> 
> Signed-off-by: Youghandhar Chintala <youghand@codeaurora.org>
> ---
>   include/net/mac80211.h     | 11 +++++++++++
>   net/mac80211/ieee80211_i.h |  3 +++
>   net/mac80211/mlme.c        | 12 ++++++++++++
>   net/mac80211/util.c        | 33 ++++++++++++++++++++++++++++++---
>   4 files changed, 56 insertions(+), 3 deletions(-)
> 
> diff --git a/include/net/mac80211.h b/include/net/mac80211.h
> index bd6912d0292b..0773c50fa182 100644
> --- a/include/net/mac80211.h
> +++ b/include/net/mac80211.h
> @@ -6064,6 +6064,17 @@ void ieee80211_disconnect(struct ieee80211_vif *vif, bool reconnect);
>    */
>   void ieee80211_resume_disconnect(struct ieee80211_vif *vif);
>   
> +/**
> + * ieee80211_hw_restart_disconnect - disconnect from AP after
> + * hardware  restart

nits:
remove excess space in "hardware  restart"

"Do not leave a blank line between the function description and the 
arguments" per 
<https://www.kernel.org/doc/html/latest/doc-guide/kernel-doc.html#function-documentation>

(I see that there is quite a mixture of compliant and non-compliant 
kernel-doc in this file)
diff mbox series

Patch

diff --git a/include/net/mac80211.h b/include/net/mac80211.h
index bd6912d0292b..0773c50fa182 100644
--- a/include/net/mac80211.h
+++ b/include/net/mac80211.h
@@ -6064,6 +6064,17 @@  void ieee80211_disconnect(struct ieee80211_vif *vif, bool reconnect);
  */
 void ieee80211_resume_disconnect(struct ieee80211_vif *vif);
 
+/**
+ * ieee80211_hw_restart_disconnect - disconnect from AP after
+ * hardware  restart
+ *
+ * @vif: &struct ieee80211_vif pointer from the add_interface callback.
+ *
+ * Instructs mac80211 to disconnect from the AP after
+ * hardware restart.
+ */
+void ieee80211_hw_restart_disconnect(struct ieee80211_vif *vif);
+
 /**
  * ieee80211_cqm_rssi_notify - inform a configured connection quality monitoring
  *	rssi threshold triggered
diff --git a/net/mac80211/ieee80211_i.h b/net/mac80211/ieee80211_i.h
index da35791b8378..7819cdf7ddfa 100644
--- a/net/mac80211/ieee80211_i.h
+++ b/net/mac80211/ieee80211_i.h
@@ -765,6 +765,8 @@  struct ieee80211_if_mesh {
  *	back to wireless media and to the local net stack.
  * @IEEE80211_SDATA_DISCONNECT_RESUME: Disconnect after resume.
  * @IEEE80211_SDATA_IN_DRIVER: indicates interface was added to driver
+ * @IEEE80211_SDATA_DISCONNECT_HW_RESTART: Disconnect after hardware restart
+ *  recovery
  */
 enum ieee80211_sub_if_data_flags {
 	IEEE80211_SDATA_ALLMULTI		= BIT(0),
@@ -772,6 +774,7 @@  enum ieee80211_sub_if_data_flags {
 	IEEE80211_SDATA_DONT_BRIDGE_PACKETS	= BIT(3),
 	IEEE80211_SDATA_DISCONNECT_RESUME	= BIT(4),
 	IEEE80211_SDATA_IN_DRIVER		= BIT(5),
+	IEEE80211_SDATA_DISCONNECT_HW_RESTART	= BIT(6),
 };
 
 /**
diff --git a/net/mac80211/mlme.c b/net/mac80211/mlme.c
index 20b57ddf149c..7e5be39dc6cc 100644
--- a/net/mac80211/mlme.c
+++ b/net/mac80211/mlme.c
@@ -4863,6 +4863,18 @@  void ieee80211_sta_restart(struct ieee80211_sub_if_data *sdata)
 		sdata_unlock(sdata);
 		return;
 	}
+
+	if (sdata->flags & IEEE80211_SDATA_DISCONNECT_HW_RESTART) {
+		sdata->flags &= ~IEEE80211_SDATA_DISCONNECT_HW_RESTART;
+		mlme_dbg(sdata, "driver requested disconnect after hardware restart\n");
+		ieee80211_sta_connection_lost(sdata,
+					      ifmgd->associated->bssid,
+					      WLAN_REASON_UNSPECIFIED,
+					      true);
+		sdata_unlock(sdata);
+		return;
+	}
+
 	sdata_unlock(sdata);
 }
 #endif
diff --git a/net/mac80211/util.c b/net/mac80211/util.c
index abc29df6834c..4b791f94751f 100644
--- a/net/mac80211/util.c
+++ b/net/mac80211/util.c
@@ -2321,6 +2321,7 @@  int ieee80211_reconfig(struct ieee80211_local *local)
 	struct cfg80211_sched_scan_request *sched_scan_req;
 	bool sched_scan_stopped = false;
 	bool suspended = local->suspended;
+	bool in_reconfig = false;
 
 	/* nothing to do if HW shouldn't run */
 	if (!local->open_count)
@@ -2672,6 +2673,7 @@  int ieee80211_reconfig(struct ieee80211_local *local)
 		drv_reconfig_complete(local, IEEE80211_RECONFIG_TYPE_RESTART);
 
 	if (local->in_reconfig) {
+		in_reconfig = local->in_reconfig;
 		local->in_reconfig = false;
 		barrier();
 
@@ -2689,6 +2691,15 @@  int ieee80211_reconfig(struct ieee80211_local *local)
 					IEEE80211_QUEUE_STOP_REASON_SUSPEND,
 					false);
 
+	if (in_reconfig) {
+		list_for_each_entry(sdata, &local->interfaces, list) {
+			if (!ieee80211_sdata_running(sdata))
+				continue;
+			if (sdata->vif.type == NL80211_IFTYPE_STATION)
+				ieee80211_sta_restart(sdata);
+		}
+	}
+
 	if (!suspended)
 		return 0;
 
@@ -2718,7 +2729,7 @@  int ieee80211_reconfig(struct ieee80211_local *local)
 	return 0;
 }
 
-void ieee80211_resume_disconnect(struct ieee80211_vif *vif)
+static void ieee80211_reconfig_disconnect(struct ieee80211_vif *vif, u8 flag)
 {
 	struct ieee80211_sub_if_data *sdata;
 	struct ieee80211_local *local;
@@ -2730,19 +2741,35 @@  void ieee80211_resume_disconnect(struct ieee80211_vif *vif)
 	sdata = vif_to_sdata(vif);
 	local = sdata->local;
 
-	if (WARN_ON(!local->resuming))
+	if (WARN_ON(flag & IEEE80211_SDATA_DISCONNECT_RESUME &&
+		    !local->resuming))
+		return;
+
+	if (WARN_ON(flag & IEEE80211_SDATA_DISCONNECT_HW_RESTART &&
+		    !local->in_reconfig))
 		return;
 
 	if (WARN_ON(vif->type != NL80211_IFTYPE_STATION))
 		return;
 
-	sdata->flags |= IEEE80211_SDATA_DISCONNECT_RESUME;
+	sdata->flags |= flag;
 
 	mutex_lock(&local->key_mtx);
 	list_for_each_entry(key, &sdata->key_list, list)
 		key->flags |= KEY_FLAG_TAINTED;
 	mutex_unlock(&local->key_mtx);
 }
+
+void ieee80211_hw_restart_disconnect(struct ieee80211_vif *vif)
+{
+	ieee80211_reconfig_disconnect(vif, IEEE80211_SDATA_DISCONNECT_HW_RESTART);
+}
+EXPORT_SYMBOL_GPL(ieee80211_hw_restart_disconnect);
+
+void ieee80211_resume_disconnect(struct ieee80211_vif *vif)
+{
+	ieee80211_reconfig_disconnect(vif, IEEE80211_SDATA_DISCONNECT_RESUME);
+}
 EXPORT_SYMBOL_GPL(ieee80211_resume_disconnect);
 
 void ieee80211_recalc_smps(struct ieee80211_sub_if_data *sdata)