diff mbox series

[v6,3/3] ath11k: Add support for beacon tx mode

Message ID 20220325055949.3035053-4-quic_mkenna@quicinc.com (mailing list archive)
State Changes Requested
Delegated to: Kalle Valo
Headers show
Series Add support to configure beacon tx mode | expand

Commit Message

Maharaja Kennadyrajan March 25, 2022, 5:59 a.m. UTC 
Add support to configure the beacon tx mode in
the driver.

Beacons can be sent out in burst(continuously in a single shot
one after another) or staggered (equally spread out over beacon
interval) mode.

Use the below configuration in the hostapd/wpa_supplicant
for AP/MESH mode to configure the beacon tx mode.

"beacon_tx_mode=N", where N = 1 for STAGGERED beacon mode
and N = 2 for BURST beacon mode.

Tested-on: IPQ8074 hw2.0 AHB WLAN.HK.2.5.0.1-00480-QCAHKSWPL_SILICONZ-1

Signed-off-by: Maharaja Kennadyrajan <quic_mkenna@quicinc.com>
---
 drivers/net/wireless/ath/ath11k/mac.c | 10 +++++++---
 1 file changed, 7 insertions(+), 3 deletions(-)
diff mbox series

Patch

diff --git a/drivers/net/wireless/ath/ath11k/mac.c b/drivers/net/wireless/ath/ath11k/mac.c
index 34a62933ccd2..46b8220a4e80 100644
--- a/drivers/net/wireless/ath/ath11k/mac.c
+++ b/drivers/net/wireless/ath/ath11k/mac.c
@@ -3125,7 +3125,10 @@  static void ath11k_mac_op_bss_info_changed(struct ieee80211_hw *hw,
 
 	if (changed & BSS_CHANGED_BEACON) {
 		param_id = WMI_PDEV_PARAM_BEACON_TX_MODE;
-		param_value = WMI_BEACON_STAGGERED_MODE;
+		if (info->beacon_tx_mode == NL80211_BEACON_BURST_MODE)
+			param_value = WMI_BEACON_BURST_MODE;
+		else
+			param_value = WMI_BEACON_STAGGERED_MODE;
 		ret = ath11k_wmi_pdev_set_param(ar, param_id,
 						param_value, ar->pdev->pdev_id);
 		if (ret)
@@ -3133,8 +3136,9 @@  static void ath11k_mac_op_bss_info_changed(struct ieee80211_hw *hw,
 				    arvif->vdev_id);
 		else
 			ath11k_dbg(ar->ab, ATH11K_DBG_MAC,
-				   "Set staggered beacon mode for VDEV: %d\n",
-				   arvif->vdev_id);
+				   "Set %s beacon mode for VDEV: %d mode: %d\n",
+				   (param_value == WMI_BEACON_BURST_MODE) ? "burst" : "staggered",
+				   arvif->vdev_id, param_value);
 
 		if (!arvif->do_not_send_tmpl || !arvif->bcca_zero_sent) {
 			ret = ath11k_mac_setup_bcn_tmpl(arvif);