@@ -3,7 +3,7 @@
* mac80211_hwsim - software simulator of 802.11 radio(s) for mac80211
* Copyright (c) 2008, Jouni Malinen <j@w1.fi>
* Copyright (c) 2011, Javier Lopez <jlopex@gmail.com>
- * Copyright (C) 2020, 2022 Intel Corporation
+ * Copyright (C) 2020, 2022-2023 Intel Corporation
*/
#ifndef __MAC80211_HWSIM_H
@@ -86,7 +86,7 @@ enum hwsim_tx_control_flags {
* with %HWSIM_CMD_REPORT_PMSR.
* @__HWSIM_CMD_MAX: enum limit
*/
-enum {
+enum hwsim_commands {
HWSIM_CMD_UNSPEC,
HWSIM_CMD_REGISTER,
HWSIM_CMD_FRAME,
@@ -117,11 +117,11 @@ enum {
* the frame was broadcasted from
* @HWSIM_ATTR_FRAME: Data array
* @HWSIM_ATTR_FLAGS: mac80211 transmission flags, used to process
- properly the frame at user space
+ * properly the frame at user space
* @HWSIM_ATTR_RX_RATE: estimated rx rate index for this frame at user
- space
+ * space
* @HWSIM_ATTR_SIGNAL: estimated RX signal for this frame at user
- space
+ * space
* @HWSIM_ATTR_TX_INFO: ieee80211_tx_rate array
* @HWSIM_ATTR_COOKIE: sk_buff cookie to identify the frame
* @HWSIM_ATTR_CHANNELS: u32 attribute used with the %HWSIM_CMD_CREATE_RADIO
@@ -140,6 +140,7 @@ enum {
* command to force radio removal when process that created the radio dies
* @HWSIM_ATTR_RADIO_NAME: Name of radio, e.g. phy666
* @HWSIM_ATTR_NO_VIF: Do not create vif (wlanX) when creating radio.
+ * @HWSIM_ATTR_PAD: padding attribute for 64-bit values, ignore
* @HWSIM_ATTR_FREQ: Frequency at which packet is transmitted or received.
* @HWSIM_ATTR_TX_INFO_FLAGS: additional flags for corresponding
* rates of %HWSIM_ATTR_TX_INFO
@@ -156,9 +157,7 @@ enum {
* to provide peer measurement result (nl80211_peer_measurement_attrs)
* @__HWSIM_ATTR_MAX: enum limit
*/
-
-
-enum {
+enum hwsim_attrs {
HWSIM_ATTR_UNSPEC,
HWSIM_ATTR_ADDR_RECEIVER,
HWSIM_ATTR_ADDR_TRANSMITTER,
@@ -259,7 +258,7 @@ enum hwsim_tx_rate_flags {
* struct hwsim_tx_rate - rate selection/status
*
* @idx: rate index to attempt to send with
- * @count: number of tries in this rate before going to the next rate
+ * @flags: the rate flags according to &enum hwsim_tx_rate_flags
*
* A value of -1 for @idx indicates an invalid rate and, if used
* in an array of retry rates, that no more rates should be tried.
@@ -287,7 +286,7 @@ struct hwsim_tx_rate_flag {
* @HWSIM_VQ_RX: receive frames and transmission info reports
* @HWSIM_NUM_VQS: enum limit
*/
-enum {
+enum hwsim_vqs {
HWSIM_VQ_TX,
HWSIM_VQ_RX,
HWSIM_NUM_VQS,