@@ -949,7 +949,8 @@ static const struct ath12k_hw_params ath12k_hw_params[] = {
.rx_mac_buf_ring = true,
.vdev_start_delay = true,
- .interface_modes = BIT(NL80211_IFTYPE_STATION),
+ .interface_modes = BIT(NL80211_IFTYPE_STATION) |
+ BIT(NL80211_IFTYPE_AP),
.supports_monitor = false,
.idle_ps = true,
@@ -6380,8 +6380,8 @@ ath12k_mac_op_assign_vif_chanctx(struct ieee80211_hw *hw,
}
if (ab->hw_params->vdev_start_delay &&
- (arvif->vdev_type == WMI_VDEV_TYPE_AP ||
- arvif->vdev_type == WMI_VDEV_TYPE_MONITOR)) {
+ arvif->vdev_type != WMI_VDEV_TYPE_AP &&
+ arvif->vdev_type != WMI_VDEV_TYPE_MONITOR) {
param.vdev_id = arvif->vdev_id;
param.peer_type = WMI_PEER_TYPE_DEFAULT;
param.peer_addr = ar->mac_addr;
For AP mode, the peer is created earlier in ath12k_mac_op_add_interface(). But ath12k_mac_op_assign_vif_chanctx() will try to create peer again. Then an error will return which make startup of AP mode fail. Kernel log: [ 5017.665006] ath12k_pci 0000:04:00.0: failed to create peer after vdev start delay: -22 wpa_supplicant log: Failed to set beacon parameters Interface initialization failed wls1: interface state UNINITIALIZED->DISABLED wls1: AP-DISABLED wls1: Unable to setup interface. Failed to initialize AP interface wls1: interface state DISABLED->DISABLED wls1: AP-DISABLED So change this check and enable AP mode for WCN7850, then soft AP can work normally. Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.0-03427-QCAHMTSWPL_V1.0_V2.0_SILICONZ-1.15378.4 Signed-off-by: Kang Yang <quic_kangyang@quicinc.com> --- drivers/net/wireless/ath/ath12k/hw.c | 3 ++- drivers/net/wireless/ath/ath12k/mac.c | 4 ++-- 2 files changed, 4 insertions(+), 3 deletions(-)