@@ -18,7 +18,6 @@
#include <linux/pci.h>
#include <linux/delay.h>
#include <linux/platform_device.h>
-#include <linux/ath9k_platform.h>
#include <linux/nvmem-consumer.h>
#include <linux/workqueue.h>
@@ -490,7 +490,7 @@ static void ath9k_hw_init_macaddr(struct ath_hw *ah)
u16 eeval;
static const u32 EEP_MAC[] = { EEP_MAC_LSW, EEP_MAC_MID, EEP_MAC_MSW };
- /* MAC address may already be loaded via ath9k_platform_data */
+ /* MAC address may already be loaded via NVMEM */
if (is_valid_ether_addr(common->macaddr))
return;
@@ -18,7 +18,6 @@
#include <linux/dma-mapping.h>
#include <linux/slab.h>
-#include <linux/ath9k_platform.h>
#include <linux/module.h>
#include <linux/of.h>
#include <linux/of_net.h>
@@ -583,8 +582,8 @@ static int ath9k_nvmem_request_eeprom(struct ath_softc *sc)
/* nvmem cell might not be defined, or the nvmem
* subsystem isn't included. In this case, follow
- * the established "just return 0;" convention of
- * ath9k_init_platform to say:
+ * the established "just return 0;" convention
+ * to say:
* "All good. Nothing to see here. Please go on."
*/
if (err == -ENOENT || err == -EOPNOTSUPP)
@@ -620,49 +619,6 @@ static int ath9k_nvmem_request_eeprom(struct ath_softc *sc)
return 0;
}
-static int ath9k_init_platform(struct ath_softc *sc)
-{
- struct ath9k_platform_data *pdata = sc->dev->platform_data;
- struct ath_hw *ah = sc->sc_ah;
- struct ath_common *common = ath9k_hw_common(ah);
- int ret;
-
- if (!pdata)
- return 0;
-
- if (!pdata->use_eeprom) {
- ah->ah_flags &= ~AH_USE_EEPROM;
- ah->gpio_mask = pdata->gpio_mask;
- ah->gpio_val = pdata->gpio_val;
- ah->led_pin = pdata->led_pin;
- ah->is_clk_25mhz = pdata->is_clk_25mhz;
- ah->get_mac_revision = pdata->get_mac_revision;
- ah->external_reset = pdata->external_reset;
- ah->disable_2ghz = pdata->disable_2ghz;
- ah->disable_5ghz = pdata->disable_5ghz;
-
- if (!pdata->endian_check)
- ah->ah_flags |= AH_NO_EEP_SWAP;
- }
-
- if (pdata->eeprom_name) {
- ret = ath9k_eeprom_request(sc, pdata->eeprom_name);
- if (ret)
- return ret;
- }
-
- if (pdata->led_active_high)
- ah->config.led_active_high = true;
-
- if (pdata->tx_gain_buffalo)
- ah->config.tx_gain_buffalo = true;
-
- if (pdata->macaddr)
- ether_addr_copy(common->macaddr, pdata->macaddr);
-
- return 0;
-}
-
static int ath9k_of_init(struct ath_softc *sc)
{
struct device_node *np = sc->dev->of_node;
@@ -755,10 +711,6 @@ static int ath9k_init_softc(u16 devid, struct ath_softc *sc,
*/
ath9k_init_pcoem_platform(sc);
- ret = ath9k_init_platform(sc);
- if (ret)
- return ret;
-
ret = ath9k_of_init(sc);
if (ret)
return ret;
deleted file mode 100644
@@ -1,51 +0,0 @@
-/*
- * Copyright (c) 2008 Atheros Communications Inc.
- * Copyright (c) 2009 Gabor Juhos <juhosg@openwrt.org>
- * Copyright (c) 2009 Imre Kaloz <kaloz@openwrt.org>
- *
- * Permission to use, copy, modify, and/or distribute this software for any
- * purpose with or without fee is hereby granted, provided that the above
- * copyright notice and this permission notice appear in all copies.
- *
- * THE SOFTWARE IS PROVIDED "AS IS" AND THE AUTHOR DISCLAIMS ALL WARRANTIES
- * WITH REGARD TO THIS SOFTWARE INCLUDING ALL IMPLIED WARRANTIES OF
- * MERCHANTABILITY AND FITNESS. IN NO EVENT SHALL THE AUTHOR BE LIABLE FOR
- * ANY SPECIAL, DIRECT, INDIRECT, OR CONSEQUENTIAL DAMAGES OR ANY DAMAGES
- * WHATSOEVER RESULTING FROM LOSS OF USE, DATA OR PROFITS, WHETHER IN AN
- * ACTION OF CONTRACT, NEGLIGENCE OR OTHER TORTIOUS ACTION, ARISING OUT OF
- * OR IN CONNECTION WITH THE USE OR PERFORMANCE OF THIS SOFTWARE.
- */
-
-#ifndef _LINUX_ATH9K_PLATFORM_H
-#define _LINUX_ATH9K_PLATFORM_H
-
-#define ATH9K_PLAT_EEP_MAX_WORDS 2048
-
-struct ath9k_platform_data {
- const char *eeprom_name;
-
- u16 eeprom_data[ATH9K_PLAT_EEP_MAX_WORDS];
- u8 *macaddr;
-
- int led_pin;
- u32 gpio_mask;
- u32 gpio_val;
-
- u32 bt_active_pin;
- u32 bt_priority_pin;
- u32 wlan_active_pin;
-
- bool endian_check;
- bool is_clk_25mhz;
- bool tx_gain_buffalo;
- bool disable_2ghz;
- bool disable_5ghz;
- bool led_active_high;
-
- int (*get_mac_revision)(void);
- int (*external_reset)(void);
-
- bool use_eeprom;
-};
-
-#endif /* _LINUX_ATH9K_PLATFORM_H */
Completely unused here in favor of Device Tree based setup. The DT code in here should currently match what is available with platform files. Any such lapse can always be added. Signed-off-by: Rosen Penev <rosenp@gmail.com> --- .../wireless/ath/ath9k/ath9k_pci_owl_loader.c | 1 - drivers/net/wireless/ath/ath9k/hw.c | 2 +- drivers/net/wireless/ath/ath9k/init.c | 52 +------------------ include/linux/ath9k_platform.h | 51 ------------------ 4 files changed, 3 insertions(+), 103 deletions(-) delete mode 100644 include/linux/ath9k_platform.h