@@ -7237,8 +7237,34 @@ void ath12k_mac_drain_tx(struct ath12k *ar)
static int ath12k_mac_config_mon_status_default(struct ath12k *ar, bool enable)
{
- return -EOPNOTSUPP;
- /* TODO: Need to support new monitor mode */
+ struct htt_rx_ring_tlv_filter tlv_filter = {};
+ struct ath12k_base *ab = ar->ab;
+ u32 ring_id, i;
+ int ret = 0;
+
+ lockdep_assert_wiphy(ath12k_ar_to_hw(ar)->wiphy);
+
+ if (!ab->hw_params->rxdma1_enable)
+ return ret;
+
+ if (enable)
+ tlv_filter = ath12k_mac_mon_status_filter_default;
+
+ for (i = 0; i < ab->hw_params->num_rxdma_per_pdev; i++) {
+ ring_id = ar->dp.rxdma_mon_dst_ring[i].ring_id;
+ ret = ath12k_dp_tx_htt_rx_filter_setup(ab, ring_id,
+ ar->dp.mac_id + i,
+ HAL_RXDMA_MONITOR_DST,
+ DP_RXDMA_REFILL_RING_SIZE,
+ &tlv_filter);
+ if (ret) {
+ ath12k_err(ab,
+ "failed to setup filter for monitor buf %d\n",
+ ret);
+ }
+ }
+
+ return ret;
}
static int ath12k_mac_start(struct ath12k *ar)
@@ -8363,29 +8389,6 @@ static void ath12k_mac_op_remove_interface(struct ieee80211_hw *hw,
FIF_PROBE_REQ | \
FIF_FCSFAIL)
-static void ath12k_mac_configure_filter(struct ath12k *ar,
- unsigned int total_flags)
-{
- bool reset_flag;
- int ret;
-
- lockdep_assert_wiphy(ath12k_ar_to_hw(ar)->wiphy);
-
- ar->filter_flags = total_flags;
-
- /* For monitor mode */
- reset_flag = !(ar->filter_flags & FIF_BCN_PRBRESP_PROMISC);
-
- ret = ath12k_dp_tx_htt_monitor_mode_ring_config(ar, reset_flag);
- if (ret)
- ath12k_warn(ar->ab,
- "fail to set monitor filter: %d\n", ret);
-
- ath12k_dbg(ar->ab, ATH12K_DBG_MAC,
- "total_flags:0x%x, reset_flag:%d\n",
- total_flags, reset_flag);
-}
-
static void ath12k_mac_op_configure_filter(struct ieee80211_hw *hw,
unsigned int changed_flags,
unsigned int *total_flags,
@@ -8399,7 +8402,7 @@ static void ath12k_mac_op_configure_filter(struct ieee80211_hw *hw,
ar = ath12k_ah_to_ar(ah, 0);
*total_flags &= SUPPORTED_FILTERS;
- ath12k_mac_configure_filter(ar, *total_flags);
+ ar->filter_flags = *total_flags;
}
static int ath12k_mac_op_get_antenna(struct ieee80211_hw *hw, u32 *tx_ant, u32 *rx_ant)
ath12k_mac_op_configure_filter() gets called multiple times during interface bringup. Applying filter configuration from this function leads to writing same filter configurations multiple times. Fix it by moving the filter configuration to ath12k_mac_op_start(). Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.3.1-00173-QCAHKSWPL_SILICONZ-1 Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.0.c5-00481-QCAHMTSWPL_V1.0_V2.0_SILICONZ-3 Signed-off-by: P Praneesh <quic_ppranees@quicinc.com> --- drivers/net/wireless/ath/ath12k/mac.c | 55 ++++++++++++++------------- 1 file changed, 29 insertions(+), 26 deletions(-)