[16/18] wl1251: fix channel switching in monitor mode

Commit Message

David Gnedt Jan. 30, 2011, 6:02 p.m. UTC

None

Patch

diff --git a/drivers/net/wireless/wl1251/main.c b/drivers/net/wireless/wl1251/main.c
index edafa98..c931a3a 100644
--- a/drivers/net/wireless/wl1251/main.c
+++ b/drivers/net/wireless/wl1251/main.c
@@ -610,8 +610,19 @@  static int wl1251_op_config(struct ieee80211_hw *hw, u32 changed)
 	if (channel != wl->channel) {
 		wl->channel = channel;
 
-		ret = wl1251_join(wl, wl->bss_type, wl->channel,
-				  wl->beacon_int, wl->dtim_period);
+		/*
+		 * Use ENABLE_RX command for channel switching when no
+		 * interface is present (monitor mode only).
+		 * This leaves the tx path disabled in firmware, whereas
+		 * the usual JOIN command seems to transmit some frames
+		 * at firmware level.
+		 */
+		if (wl->vif == NULL) {
+			ret = wl1251_cmd_data_path_rx(wl, wl->channel, 1);
+		} else {
+			ret = wl1251_join(wl, wl->bss_type, wl->channel,
+					  wl->beacon_int, wl->dtim_period);
+		}
 		if (ret < 0)
 			goto out_sleep;
 	}