@@ -30,6 +30,9 @@ static void mt76x02_pre_tbtt_tasklet(unsigned long arg)
struct sk_buff *skb;
int i;
+ if (mt76_hw(dev)->conf.flags & IEEE80211_CONF_OFFCHANNEL)
+ return;
+
mt76x02_resync_beacon_timer(dev);
ieee80211_iterate_active_interfaces_atomic(mt76_hw(dev),
@@ -178,6 +178,9 @@ static void mt76x02u_pre_tbtt_work(struct work_struct *work)
if (!dev->mt76.beacon_mask)
return;
+ if (mt76_hw(dev)->conf.flags & IEEE80211_CONF_OFFCHANNEL)
+ return;
+
mt76x02_resync_beacon_timer(dev);
ieee80211_iterate_active_interfaces(mt76_hw(dev),
@@ -593,8 +593,6 @@ void mt76x02_sw_scan(struct ieee80211_hw *hw, struct ieee80211_vif *vif,
{
struct mt76x02_dev *dev = hw->priv;
- if (mt76_is_mmio(dev))
- tasklet_disable(&dev->mt76.pre_tbtt_tasklet);
set_bit(MT76_SCANNING, &dev->mt76.state);
}
EXPORT_SYMBOL_GPL(mt76x02_sw_scan);
@@ -605,9 +603,6 @@ void mt76x02_sw_scan_complete(struct ieee80211_hw *hw,
struct mt76x02_dev *dev = hw->priv;
clear_bit(MT76_SCANNING, &dev->mt76.state);
- if (mt76_is_mmio(dev))
- tasklet_enable(&dev->mt76.pre_tbtt_tasklet);
-
if (dev->cal.gain_init_done) {
/* Restore AGC gain and resume calibration after scanning. */
dev->cal.low_gain = -1;
Do not enable/disable pre_tbtt_tasklet tasklet in mt76x02_sw_scan/mt76x02_sw_scan_complete since it is already done setting the operating channel. Do run tbtt_tasklet while the device is offchannel Signed-off-by: Lorenzo Bianconi <lorenzo@kernel.org> --- drivers/net/wireless/mediatek/mt76/mt76x02_mmio.c | 3 +++ drivers/net/wireless/mediatek/mt76/mt76x02_usb_core.c | 3 +++ drivers/net/wireless/mediatek/mt76/mt76x02_util.c | 5 ----- 3 files changed, 6 insertions(+), 5 deletions(-)