Show patches with: Submitter = Lars-Peter Clausen       |   26 patches
Patch Series A/R/T S/W/F Date Submitter Delegate State
[3/3] spi: spi-sn-f-ospi: Make read-only array `width_available` static const [1/3] spi: spi-sn-f-ospi: Use devm_clk_get_enabled() - - - --- 2023-05-28 Lars-Peter Clausen Accepted
[2/3] spi: spi-sn-f-ospi: Use min_t instead of opencoding it [1/3] spi: spi-sn-f-ospi: Use devm_clk_get_enabled() - - - --- 2023-05-28 Lars-Peter Clausen Accepted
[1/3] spi: spi-sn-f-ospi: Use devm_clk_get_enabled() [1/3] spi: spi-sn-f-ospi: Use devm_clk_get_enabled() - - - --- 2023-05-28 Lars-Peter Clausen Accepted
spi: cadence: Detect transmit FIFO depth spi: cadence: Detect transmit FIFO depth - - - --- 2022-05-27 Lars-Peter Clausen Accepted
[2/2] spi: altera: Consolidate TX/RX data register access - - - --- 2017-08-16 Lars-Peter Clausen Accepted
[1/2] spi: altera: Switch to SPI core transfer queue management - - - --- 2017-08-16 Lars-Peter Clausen Accepted
[v2,2/2] spi: xilinx: Return IRQ_NONE if no interrupts were detected 1 - - --- 2016-07-15 Lars-Peter Clausen New
[v2,1/2] spi: xilinx: Handle errors from platform_get_irq() 1 - - --- 2016-07-15 Lars-Peter Clausen Accepted
[2/2] spi: xilinx: Return IRQ_NONE if no interrupts were detected 1 - - --- 2016-07-12 Lars-Peter Clausen Accepted
[1/2] spi: xilinx: Handle errors from platform_get_irq() 1 - - --- 2016-07-12 Lars-Peter Clausen New
[2/2] spi: Add Analog Devices AXI SPI Engine controller support - - - --- 2016-02-04 Lars-Peter Clausen Accepted
[1/2] devicetree: Add bindings documentation for Analog Devices axi-spi-engine - - - --- 2016-02-04 Lars-Peter Clausen Accepted
[2/2] spi: Remove support for legacy PM - - - --- 2015-03-08 Lars-Peter Clausen Accepted
[1/2] spi: Use PM ops instead of legacy suspend/resume - - - --- 2015-03-08 Lars-Peter Clausen Accepted
[2/2] spi: cadence: Fix 3-to-8 mux mode - - - --- 2014-11-27 Lars-Peter Clausen Accepted
[1/2] spi: cadence: Init HW after reading devicetree attributes - - - --- 2014-11-27 Lars-Peter Clausen Accepted
[2/2] spi: cadence: Configure SPI clock in the prepare_message() callback - - - --- 2014-07-10 Lars-Peter Clausen Accepted
[1/2] spi: cadence: Make sure that clock polarity changes are applied - - - --- 2014-07-10 Lars-Peter Clausen Accepted
spi: xilinx: Use pdev->id instead of pdev->dev.id for the SPI bus number - - - --- 2014-07-10 Lars-Peter Clausen Accepted
spi: topcliff-pch: Pass correct pointer to free_irq() - - - --- 2013-05-20 Lars-Peter Clausen Superseded
[3/3] staging:iio: Use spi_sync_transfer() - - - --- 2013-01-09 Lars-Peter Clausen Superseded
[2/3] iio: Use spi_sync_transfer() - - - --- 2013-01-09 Lars-Peter Clausen Superseded
[1/3] spi: Add helper functions for setting up transfers - - - --- 2013-01-09 Lars-Peter Clausen Superseded
[resend] spi: Add support for specifying 3-wire mode via device tree - - - --- 2012-12-06 Lars-Peter Clausen Superseded
[resend] spi: Add AD-FMCOMMS1-EBZ I2C-SPI bridge driver - - - --- 2012-07-19 Lars-Peter Clausen Superseded
spi: Add support for specifing 3-wire mode via device tree - - - --- 2012-07-13 Lars-Peter Clausen Superseded