| Message ID | 20201019182323.3162386-4-bjorn.andersson@linaro.org (mailing list archive) |
|---|---|
| State | Accepted |
| Commit | f9081b8ff5934b8d69c748d0200e844cadd2c667 |
| Headers | show |
| Series | iommu/arm-smmu-qcom: Support maintaining bootloader mappings | expand |
On 2020-10-19 19:23, Bjorn Andersson wrote: > The firmware found in some Qualcomm platforms intercepts writes to S2CR > in order to replace bypass type streams with fault; and ignore S2CR > updates of type fault. > > Detect this behavior and implement a custom write_s2cr function in order > to trick the firmware into supporting bypass streams by the means of > configuring the stream for translation using a reserved and disabled > context bank. > > Also circumvent the problem of configuring faulting streams by > configuring the stream as bypass. > > Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org> > --- > > Changes since v4: > - Made the bypass_cbndx an integer... > - Separated out the "quirk enabled or not" into a bool, rather than reusing > (the valid) context bank 0 to represent this. > - Dropped the unused EXIDS handling. > > drivers/iommu/arm/arm-smmu/arm-smmu-qcom.c | 67 ++++++++++++++++++++++ > 1 file changed, 67 insertions(+) > > diff --git a/drivers/iommu/arm/arm-smmu/arm-smmu-qcom.c b/drivers/iommu/arm/arm-smmu/arm-smmu-qcom.c > index 48627fcf6bed..66ba4870659f 100644 > --- a/drivers/iommu/arm/arm-smmu/arm-smmu-qcom.c > +++ b/drivers/iommu/arm/arm-smmu/arm-smmu-qcom.c > @@ -10,8 +10,15 @@ > > struct qcom_smmu { > struct arm_smmu_device smmu; > + bool bypass_quirk; > + u8 bypass_cbndx; > }; > > +static struct qcom_smmu *to_qcom_smmu(struct arm_smmu_device *smmu) > +{ > + return container_of(smmu, struct qcom_smmu, smmu); > +} > + > static const struct of_device_id qcom_smmu_client_of_match[] __maybe_unused = { > { .compatible = "qcom,adreno" }, > { .compatible = "qcom,mdp4" }, > @@ -25,9 +32,33 @@ static const struct of_device_id qcom_smmu_client_of_match[] __maybe_unused = { > > static int qcom_smmu_cfg_probe(struct arm_smmu_device *smmu) > { > + unsigned int last_s2cr = ARM_SMMU_GR0_S2CR(smmu->num_mapping_groups - 1); > + struct qcom_smmu *qsmmu = to_qcom_smmu(smmu); > + u32 reg; > u32 smr; > int i; > > + /* > + * With some firmware versions writes to S2CR of type FAULT are > + * ignored, and writing BYPASS will end up written as FAULT in the > + * register. Perform a write to S2CR to detect if this is the case and > + * if so reserve a context bank to emulate bypass streams. > + */ > + reg = FIELD_PREP(ARM_SMMU_S2CR_TYPE, S2CR_TYPE_BYPASS) | > + FIELD_PREP(ARM_SMMU_S2CR_CBNDX, 0xff) | > + FIELD_PREP(ARM_SMMU_S2CR_PRIVCFG, S2CR_PRIVCFG_DEFAULT); > + arm_smmu_gr0_write(smmu, last_s2cr, reg); > + reg = arm_smmu_gr0_read(smmu, last_s2cr); > + if (FIELD_GET(ARM_SMMU_S2CR_TYPE, reg) != S2CR_TYPE_BYPASS) { > + qsmmu->bypass_quirk = true; > + qsmmu->bypass_cbndx = smmu->num_context_banks - 1; FWIW you could arguably just calculate that at point of use. Or store the index as an int and use a negative value to indicate when it's irrelevant to save the separate flag. But there's also nothing *wrong* with having it all spelled out, so regardless, Acked-by: Robin Murphy <robin.murphy@arm.com> Cheers, Robin. > + > + set_bit(qsmmu->bypass_cbndx, smmu->context_map); > + > + reg = FIELD_PREP(ARM_SMMU_CBAR_TYPE, CBAR_TYPE_S1_TRANS_S2_BYPASS); > + arm_smmu_gr1_write(smmu, ARM_SMMU_GR1_CBAR(qsmmu->bypass_cbndx), reg); > + } > + > for (i = 0; i < smmu->num_mapping_groups; i++) { > smr = arm_smmu_gr0_read(smmu, ARM_SMMU_GR0_SMR(i)); > > @@ -45,6 +76,41 @@ static int qcom_smmu_cfg_probe(struct arm_smmu_device *smmu) > return 0; > } > > +static void qcom_smmu_write_s2cr(struct arm_smmu_device *smmu, int idx) > +{ > + struct arm_smmu_s2cr *s2cr = smmu->s2crs + idx; > + struct qcom_smmu *qsmmu = to_qcom_smmu(smmu); > + u32 cbndx = s2cr->cbndx; > + u32 type = s2cr->type; > + u32 reg; > + > + if (qsmmu->bypass_quirk) { > + if (type == S2CR_TYPE_BYPASS) { > + /* > + * Firmware with quirky S2CR handling will substitute > + * BYPASS writes with FAULT, so point the stream to the > + * reserved context bank and ask for translation on the > + * stream > + */ > + type = S2CR_TYPE_TRANS; > + cbndx = qsmmu->bypass_cbndx; > + } else if (type == S2CR_TYPE_FAULT) { > + /* > + * Firmware with quirky S2CR handling will ignore FAULT > + * writes, so trick it to write FAULT by asking for a > + * BYPASS. > + */ > + type = S2CR_TYPE_BYPASS; > + cbndx = 0xff; > + } > + } > + > + reg = FIELD_PREP(ARM_SMMU_S2CR_TYPE, type) | > + FIELD_PREP(ARM_SMMU_S2CR_CBNDX, cbndx) | > + FIELD_PREP(ARM_SMMU_S2CR_PRIVCFG, s2cr->privcfg); > + arm_smmu_gr0_write(smmu, ARM_SMMU_GR0_S2CR(idx), reg); > +} > + > static int qcom_smmu_def_domain_type(struct device *dev) > { > const struct of_device_id *match = > @@ -86,6 +152,7 @@ static const struct arm_smmu_impl qcom_smmu_impl = { > .cfg_probe = qcom_smmu_cfg_probe, > .def_domain_type = qcom_smmu_def_domain_type, > .reset = qcom_smmu500_reset, > + .write_s2cr = qcom_smmu_write_s2cr, > }; > > struct arm_smmu_device *qcom_smmu_impl_init(struct arm_smmu_device *smmu) >
diff --git a/drivers/iommu/arm/arm-smmu/arm-smmu-qcom.c b/drivers/iommu/arm/arm-smmu/arm-smmu-qcom.c index 48627fcf6bed..66ba4870659f 100644 --- a/drivers/iommu/arm/arm-smmu/arm-smmu-qcom.c +++ b/drivers/iommu/arm/arm-smmu/arm-smmu-qcom.c @@ -10,8 +10,15 @@ struct qcom_smmu { struct arm_smmu_device smmu; + bool bypass_quirk; + u8 bypass_cbndx; }; +static struct qcom_smmu *to_qcom_smmu(struct arm_smmu_device *smmu) +{ + return container_of(smmu, struct qcom_smmu, smmu); +} + static const struct of_device_id qcom_smmu_client_of_match[] __maybe_unused = { { .compatible = "qcom,adreno" }, { .compatible = "qcom,mdp4" }, @@ -25,9 +32,33 @@ static const struct of_device_id qcom_smmu_client_of_match[] __maybe_unused = { static int qcom_smmu_cfg_probe(struct arm_smmu_device *smmu) { + unsigned int last_s2cr = ARM_SMMU_GR0_S2CR(smmu->num_mapping_groups - 1); + struct qcom_smmu *qsmmu = to_qcom_smmu(smmu); + u32 reg; u32 smr; int i; + /* + * With some firmware versions writes to S2CR of type FAULT are + * ignored, and writing BYPASS will end up written as FAULT in the + * register. Perform a write to S2CR to detect if this is the case and + * if so reserve a context bank to emulate bypass streams. + */ + reg = FIELD_PREP(ARM_SMMU_S2CR_TYPE, S2CR_TYPE_BYPASS) | + FIELD_PREP(ARM_SMMU_S2CR_CBNDX, 0xff) | + FIELD_PREP(ARM_SMMU_S2CR_PRIVCFG, S2CR_PRIVCFG_DEFAULT); + arm_smmu_gr0_write(smmu, last_s2cr, reg); + reg = arm_smmu_gr0_read(smmu, last_s2cr); + if (FIELD_GET(ARM_SMMU_S2CR_TYPE, reg) != S2CR_TYPE_BYPASS) { + qsmmu->bypass_quirk = true; + qsmmu->bypass_cbndx = smmu->num_context_banks - 1; + + set_bit(qsmmu->bypass_cbndx, smmu->context_map); + + reg = FIELD_PREP(ARM_SMMU_CBAR_TYPE, CBAR_TYPE_S1_TRANS_S2_BYPASS); + arm_smmu_gr1_write(smmu, ARM_SMMU_GR1_CBAR(qsmmu->bypass_cbndx), reg); + } + for (i = 0; i < smmu->num_mapping_groups; i++) { smr = arm_smmu_gr0_read(smmu, ARM_SMMU_GR0_SMR(i)); @@ -45,6 +76,41 @@ static int qcom_smmu_cfg_probe(struct arm_smmu_device *smmu) return 0; } +static void qcom_smmu_write_s2cr(struct arm_smmu_device *smmu, int idx) +{ + struct arm_smmu_s2cr *s2cr = smmu->s2crs + idx; + struct qcom_smmu *qsmmu = to_qcom_smmu(smmu); + u32 cbndx = s2cr->cbndx; + u32 type = s2cr->type; + u32 reg; + + if (qsmmu->bypass_quirk) { + if (type == S2CR_TYPE_BYPASS) { + /* + * Firmware with quirky S2CR handling will substitute + * BYPASS writes with FAULT, so point the stream to the + * reserved context bank and ask for translation on the + * stream + */ + type = S2CR_TYPE_TRANS; + cbndx = qsmmu->bypass_cbndx; + } else if (type == S2CR_TYPE_FAULT) { + /* + * Firmware with quirky S2CR handling will ignore FAULT + * writes, so trick it to write FAULT by asking for a + * BYPASS. + */ + type = S2CR_TYPE_BYPASS; + cbndx = 0xff; + } + } + + reg = FIELD_PREP(ARM_SMMU_S2CR_TYPE, type) | + FIELD_PREP(ARM_SMMU_S2CR_CBNDX, cbndx) | + FIELD_PREP(ARM_SMMU_S2CR_PRIVCFG, s2cr->privcfg); + arm_smmu_gr0_write(smmu, ARM_SMMU_GR0_S2CR(idx), reg); +} + static int qcom_smmu_def_domain_type(struct device *dev) { const struct of_device_id *match = @@ -86,6 +152,7 @@ static const struct arm_smmu_impl qcom_smmu_impl = { .cfg_probe = qcom_smmu_cfg_probe, .def_domain_type = qcom_smmu_def_domain_type, .reset = qcom_smmu500_reset, + .write_s2cr = qcom_smmu_write_s2cr, }; struct arm_smmu_device *qcom_smmu_impl_init(struct arm_smmu_device *smmu)
The firmware found in some Qualcomm platforms intercepts writes to S2CR in order to replace bypass type streams with fault; and ignore S2CR updates of type fault. Detect this behavior and implement a custom write_s2cr function in order to trick the firmware into supporting bypass streams by the means of configuring the stream for translation using a reserved and disabled context bank. Also circumvent the problem of configuring faulting streams by configuring the stream as bypass. Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org> --- Changes since v4: - Made the bypass_cbndx an integer... - Separated out the "quirk enabled or not" into a bool, rather than reusing (the valid) context bank 0 to represent this. - Dropped the unused EXIDS handling. drivers/iommu/arm/arm-smmu/arm-smmu-qcom.c | 67 ++++++++++++++++++++++ 1 file changed, 67 insertions(+)