@@ -12,11 +12,11 @@
#define USE_HW_I2C
#ifdef USE_HW_I2C
- #define i2cWriteReg sm750_hw_i2c_write_reg
- #define i2cReadReg sm750_hw_i2c_read_reg
+ #define i2c_write_reg sm750_hw_i2c_write_reg
+ #define i2c_read_reg sm750_hw_i2c_read_reg
#else
- #define i2cWriteReg sm750_sw_i2c_write_reg
- #define i2cReadReg sm750_sw_i2c_read_reg
+ #define i2c_write_reg sm750_sw_i2c_write_reg
+ #define i2c_read_reg sm750_sw_i2c_read_reg
#endif
/* SII164 Vendor and Device ID */
@@ -39,9 +39,9 @@ unsigned short sii164_get_vendor_id(void)
{
unsigned short vendorID;
- vendorID = ((unsigned short)i2cReadReg(SII164_I2C_ADDRESS,
+ vendorID = ((unsigned short)i2c_read_reg(SII164_I2C_ADDRESS,
SII164_VENDOR_ID_HIGH) << 8) |
- (unsigned short)i2cReadReg(SII164_I2C_ADDRESS,
+ (unsigned short)i2c_read_reg(SII164_I2C_ADDRESS,
SII164_VENDOR_ID_LOW);
return vendorID;
@@ -58,9 +58,9 @@ unsigned short sii164_get_device_id(void)
{
unsigned short deviceID;
- deviceID = ((unsigned short)i2cReadReg(SII164_I2C_ADDRESS,
+ deviceID = ((unsigned short)i2c_read_reg(SII164_I2C_ADDRESS,
SII164_DEVICE_ID_HIGH) << 8) |
- (unsigned short)i2cReadReg(SII164_I2C_ADDRESS,
+ (unsigned short)i2c_read_reg(SII164_I2C_ADDRESS,
SII164_DEVICE_ID_LOW);
return deviceID;
@@ -176,7 +176,7 @@ long sii164_init_chip(unsigned char edge_select,
else
config |= SII164_CONFIGURATION_VSYNC_AS_IS;
- i2cWriteReg(SII164_I2C_ADDRESS, SII164_CONFIGURATION, config);
+ i2c_write_reg(SII164_I2C_ADDRESS, SII164_CONFIGURATION, config);
/*
* De-skew enabled with default 111b value.
@@ -214,7 +214,7 @@ long sii164_init_chip(unsigned char edge_select,
config |= SII164_DESKEW_8_STEP;
break;
}
- i2cWriteReg(SII164_I2C_ADDRESS, SII164_DESKEW, config);
+ i2c_write_reg(SII164_I2C_ADDRESS, SII164_DESKEW, config);
/* Enable/Disable Continuous Sync. */
if (continuous_sync_enable == 0)
@@ -231,12 +231,12 @@ long sii164_init_chip(unsigned char edge_select,
/* Set the PLL Filter value */
config |= ((pll_filter_value & 0x07) << 1);
- i2cWriteReg(SII164_I2C_ADDRESS, SII164_PLL, config);
+ i2c_write_reg(SII164_I2C_ADDRESS, SII164_PLL, config);
/* Recover from Power Down and enable output. */
- config = i2cReadReg(SII164_I2C_ADDRESS, SII164_CONFIGURATION);
+ config = i2c_read_reg(SII164_I2C_ADDRESS, SII164_CONFIGURATION);
config |= SII164_CONFIGURATION_POWER_NORMAL;
- i2cWriteReg(SII164_I2C_ADDRESS, SII164_CONFIGURATION, config);
+ i2c_write_reg(SII164_I2C_ADDRESS, SII164_CONFIGURATION, config);
return 0;
}
@@ -283,17 +283,17 @@ void sii164_set_power(unsigned char powerUp)
{
unsigned char config;
- config = i2cReadReg(SII164_I2C_ADDRESS, SII164_CONFIGURATION);
+ config = i2c_read_reg(SII164_I2C_ADDRESS, SII164_CONFIGURATION);
if (powerUp == 1) {
/* Power up the chip */
config &= ~SII164_CONFIGURATION_POWER_MASK;
config |= SII164_CONFIGURATION_POWER_NORMAL;
- i2cWriteReg(SII164_I2C_ADDRESS, SII164_CONFIGURATION, config);
+ i2c_write_reg(SII164_I2C_ADDRESS, SII164_CONFIGURATION, config);
} else {
/* Power down the chip */
config &= ~SII164_CONFIGURATION_POWER_MASK;
config |= SII164_CONFIGURATION_POWER_DOWN;
- i2cWriteReg(SII164_I2C_ADDRESS, SII164_CONFIGURATION, config);
+ i2c_write_reg(SII164_I2C_ADDRESS, SII164_CONFIGURATION, config);
}
}
@@ -306,7 +306,7 @@ void sii164SelectHotPlugDetectionMode(enum sii164_hot_plug_mode hotPlugMode)
{
unsigned char detectReg;
- detectReg = i2cReadReg(SII164_I2C_ADDRESS, SII164_DETECT) &
+ detectReg = i2c_read_reg(SII164_I2C_ADDRESS, SII164_DETECT) &
~SII164_DETECT_MONITOR_SENSE_OUTPUT_FLAG;
switch (hotPlugMode) {
case SII164_HOTPLUG_DISABLE:
@@ -325,7 +325,7 @@ void sii164SelectHotPlugDetectionMode(enum sii164_hot_plug_mode hotPlugMode)
break;
}
- i2cWriteReg(SII164_I2C_ADDRESS, SII164_DETECT, detectReg);
+ i2c_write_reg(SII164_I2C_ADDRESS, SII164_DETECT, detectReg);
}
/*
@@ -338,7 +338,7 @@ void sii164_enable_hot_plug_detection(unsigned char enableHotPlug)
{
unsigned char detectReg;
- detectReg = i2cReadReg(SII164_I2C_ADDRESS, SII164_DETECT);
+ detectReg = i2c_read_reg(SII164_I2C_ADDRESS, SII164_DETECT);
/* Depending on each DVI controller, need to enable the hot plug based
* on each individual chip design.
@@ -361,7 +361,7 @@ unsigned char sii164_is_connected(void)
{
unsigned char hotPlugValue;
- hotPlugValue = i2cReadReg(SII164_I2C_ADDRESS, SII164_DETECT) &
+ hotPlugValue = i2c_read_reg(SII164_I2C_ADDRESS, SII164_DETECT) &
SII164_DETECT_HOT_PLUG_STATUS_MASK;
if (hotPlugValue == SII164_DETECT_HOT_PLUG_STATUS_ON)
return 1;
@@ -381,7 +381,7 @@ unsigned char sii164_check_interrupt(void)
{
unsigned char detectReg;
- detectReg = i2cReadReg(SII164_I2C_ADDRESS, SII164_DETECT) &
+ detectReg = i2c_read_reg(SII164_I2C_ADDRESS, SII164_DETECT) &
SII164_DETECT_MONITOR_STATE_MASK;
if (detectReg == SII164_DETECT_MONITOR_STATE_CHANGE)
return 1;
@@ -398,8 +398,8 @@ void sii164_clear_interrupt(void)
unsigned char detectReg;
/* Clear the MDI interrupt */
- detectReg = i2cReadReg(SII164_I2C_ADDRESS, SII164_DETECT);
- i2cWriteReg(SII164_I2C_ADDRESS, SII164_DETECT,
+ detectReg = i2c_read_reg(SII164_I2C_ADDRESS, SII164_DETECT);
+ i2c_write_reg(SII164_I2C_ADDRESS, SII164_DETECT,
detectReg | SII164_DETECT_MONITOR_STATE_CLEAR);
}
Fix "Avoid CamelCase" checkpatch.pl checks for i2cWriteReg and i2cReadReg in ddk750_sii164.c. Signed-off-by: Pavle Rohalj <pavle.rohalj@gmail.com> --- drivers/staging/sm750fb/ddk750_sii164.c | 46 ++++++++++++------------- 1 file changed, 23 insertions(+), 23 deletions(-)