Show patches with: Submitter = Philip Rakity       |    State = Action Required       |   163 patches
« 1 2 »
Patch Series A/R/T S/W/F Date Submitter Delegate State
[v2] mmc: sdhci: fix incorrect command used in tuning - - - --- 2012-07-03 Philip Rakity New
mmc: sdhci: fix retuning timer wrongly deleted in sdhci_tasklet_finish - - - --- 2011-07-21 Philip Rakity New
sdhci: pxav3 controller needs 32 bit ADMA addressing - - - --- 2011-07-11 Philip Rakity New
sdhci: If ADMA is broken try SDMA before PIO - - - --- 2011-07-11 Philip Rakity New
[V2] mmc: Bus width testing needs to handle suspend/resume - - - --- 2011-07-07 Philip Rakity New
[v4] arm: mach-mmp: brownstone.c support multiple sd slots - - - --- 2011-07-06 Philip Rakity New
[V2] mmc: sd.c Set Non Default Drive Strength via platform - - - --- 2011-07-06 Philip Rakity New
mmc: sd.c Set Non Default Drive Strength via platform - - - --- 2011-07-06 Philip Rakity New
[v3] arm: mach-mmp: brownstone.c support multiple sd slots - - - --- 2011-07-05 Philip Rakity New
Bus Width Testing on Suspend/Resume (REGRESSION) - - - --- 2011-07-01 Philip Rakity New
[RFC] sdhci: suspend code correct ? - - - --- 2011-06-23 Philip Rakity New
[V2] mmc: eMMC bus width may not work on all platforms - - - --- 2011-05-25 Philip Rakity New
[V2] mmc: eMMC bus width may not work on all platforms - - - --- 2011-05-22 Philip Rakity New
[RFC,v2] mmc: Non Default UHS Drive Strength must use board specific code - - - --- 2011-05-18 Philip Rakity New
[RFC] mmc: Non Default UHS Drive Strength must use board specific code - - - --- 2011-05-17 Philip Rakity New
mmc: eMMC bus width may not work on all platforms - - - --- 2011-05-17 Philip Rakity New
[V2] mmc: sdhci add explicit callback to set f_max - - - --- 2011-04-29 Philip Rakity New
[v2] arm: mach-mmp: brownstone.c support multiple sd slots - - - --- 2011-04-28 Philip Rakity New
plat-pxa: Enable ability to adjust SD/MMC clocks - - - --- 2011-04-27 Philip Rakity New
mmc: Add support for eMMC Dual Data Rate - - - --- 2011-04-22 Philip Rakity New
mmc: eMMC signal voltage does not use CMD11 - - - --- 2011-04-22 Philip Rakity New
sdhci-pxa: add platform specific code for UHS signaling - - - --- 2011-04-22 Philip Rakity New
sdhci: add hooks for UHS setting by platform specific code - - - --- 2011-04-22 Philip Rakity New
sdhci: Kconfig: Restrict PLAT_PXA to MMP2 only. Other processors not supported - - - --- 2011-04-22 Philip Rakity New
[PATCH sdhci: sdhci-pxa.c: Add QUIRKS for DMA/ADMA to match h/w - - - --- 2011-04-22 Philip Rakity New
sdhci: sdhci-pxa.c: Add post reset processing for chip specific registers - - - --- 2011-04-22 Philip Rakity New
sdhci: sdhci-pxa.c enable CAP support for cards marked permanent - - - --- 2011-04-22 Philip Rakity New
sdhci: sdhci-pxa.c ensure clocks are enabled on all SD controllers - - - --- 2011-04-22 Philip Rakity New
plat-pxa: add missing define for PERMANENT CARDS - - - --- 2011-04-22 Philip Rakity New
Subject: [PATCH] sdhci: sdhci-pxa.c: Enable BUS WIDTH testing for MMC/eMMC cards - - - --- 2011-04-22 Philip Rakity New
sdhci: sdhci-pxa.c: delete clk gating code - not correct - - - --- 2011-04-22 Philip Rakity New
plat-pxa: Enable ability to adjust SD/MMC clocks - - - --- 2011-04-22 Philip Rakity New
[V2] arm: mach-mmp: brownstone.c support multiple sd slots - - - --- 2011-02-26 Philip Rakity New
[V2] sdhci: always use max timeout for xfers - - - --- 2011-02-25 Philip Rakity New
sdhci: always use max timeout for xfers - - - --- 2011-02-25 Philip Rakity New
[V2] sdhci: sdhci.c: Do not disable global interrupts while waiting in set_ios - - - --- 2011-02-15 Philip Rakity New
[2/4] arm: V2 configs: update pxa168 defconfig for SoC Selection - - - --- 2011-02-15 Philip Rakity New
[4/4] arm: V2 configs: update pxa910 defconfig for SoC Selection - - - --- 2011-02-15 Philip Rakity New
[2/4] arm: V2 configs: update mmp2 defconfig for brownstone and SoC Selection - - - --- 2011-02-15 Philip Rakity New
[2/2] mach-mmp: Support for SD/MMC clock adjustment in brownstone - - - --- 2011-02-14 Philip Rakity New
sdhci: Add support PXA168, PXA910, and MMP2 controllers - - - --- 2011-02-14 Philip Rakity New
[2/2] sdhci: sdhci-pxa: add support for hardware clock gating callback - - - --- 2011-02-14 Philip Rakity New
[1/2] mmc: add support for H/W clock gating of SD controller - - - --- 2011-02-14 Philip Rakity New
sdhci: add ops to force delay in operations due to silicon issues - - - --- 2011-02-14 Philip Rakity New
[4/4] sdhci: sdhci-pxa.c: add callback for signaling for DDR - - - --- 2011-02-14 Philip Rakity New
[3/4] mmc: sdhci: Support for SD/MMC Dual Data Rate - - - --- 2011-02-14 Philip Rakity New
[2/4] sdhci: register defs for sd 3.0 HOST CONTROL 2 - - - --- 2011-02-14 Philip Rakity New
[1/4] mmc: rename ddr to uhs in ios structure to indicate usage - - - --- 2011-02-14 Philip Rakity New
mmc: rename ddr to uhs in ios structure to indicate usage - - - --- 2011-02-14 Philip Rakity New
mmc: mmc.c check if mmc cards < 2GB do sector addressing - - - --- 2011-02-14 Philip Rakity New
mmc: core: add comment why sdio_reset is done at init time - - - --- 2011-02-14 Philip Rakity New
[2/2] sdhci: sdhci-pxa.c add host->ops to configure f_max - - - --- 2011-02-14 Philip Rakity New
[1/2] sdhci: sdhci.[ch] support setting f_max clock via call back - - - --- 2011-02-14 Philip Rakity New
[2/2] sdhci: sdhci-pxa.c: Add post reset processing for chip specific registers - - - --- 2011-02-14 Philip Rakity New
[1/2] sdhci: sdhci.c: Add pre / post reset processing for chip specific reset - - - --- 2011-02-14 Philip Rakity New
[RFC] sdhci: sdhci.c: Do not disable global interrupts while waiting in set_ios - - - --- 2011-02-14 Philip Rakity New
[5/5] sdhci: sdhci-pxa.c: Add QUIRKS for DMA/ADMA to match h/w - - - --- 2011-02-14 Philip Rakity New
[4/5] sdhci: sdhci-pxa.c: Enable BUS WIDTH testing for MMC/eMMC cards - - - --- 2011-02-14 Philip Rakity New
[3/5] sdhci: sdhci-pxa.c enable CAP support for cards marked permanent - - - --- 2011-02-14 Philip Rakity New
[2/5] sdhci: sdhci-pxa.c ensure clocks are enabled on all SD controllers - - - --- 2011-02-14 Philip Rakity New
[1/5] sdhci: sdhci-pxa.c: delete clk gating code - not correct - - - --- 2011-02-14 Philip Rakity New
[2/2] mach-mmp: Support for SD/MMC clock adjustment in brownstone - - - --- 2011-02-14 Philip Rakity New
[1/2] plat-pxa: Enable ability to adjust SD/MMC clocks - - - --- 2011-02-14 Philip Rakity New
[5/5] arm: mach-mmp: brownstone.c support multiple sd slots - - - --- 2011-02-14 Philip Rakity New
[4/5] mach-mmp: PXA168: support multiple SD controllers - - - --- 2011-02-14 Philip Rakity New
[3/5] plat-pxa: sdhci.h define for PERMANENT SD/eMMC/SDIO cards - - - --- 2011-02-14 Philip Rakity New
[2/5] arm: mach-mmp: mmp2.c use revised APMU registers defines for APMU_CLK_OPS - - - --- 2011-02-14 Philip Rakity New
[1/5] arm: mach-mmp: SDH register definitions for (pxa168, pxa910, mmp2) - - - --- 2011-02-14 Philip Rakity New
[4/4] arm: configs: update pxa910 defconfig for SoC Selection - - - --- 2011-02-14 Philip Rakity New
[3/4] arm: configs: update pxa168 defconfig for SoC Selection - - - --- 2011-02-14 Philip Rakity New
[2/4] arm: configs: update mmp2 defconfig for brownstone and SoC Selection - - - --- 2011-02-14 Philip Rakity New
[[PATCH,1/4] arm: mach-mmp: Fix Kconfig to allow correct PXA Selections - - - --- 2011-02-14 Philip Rakity New
[RFC} sdhci.c set_ios -- disable global interrupts and Question on Power Management - - - --- 2011-02-14 Philip Rakity New
[RFC} sdhci.c set_ios -- disable global interrupts and Question on Power Management - - - --- 2011-02-13 Philip Rakity New
[BUG] CMD52 sent as first command not CMD0 - - - --- 2011-02-06 Philip Rakity New
[BUG] CMD52 sent as first command not CMD0 - - - --- 2011-02-04 Philip Rakity New
mmc: ensure linux does start in eMMC private boot partition - - - --- 2011-02-01 Philip Rakity New
mmc: check if mmc cards < 2GB do sector addressing - - - --- 2011-01-27 Philip Rakity New
sdhci: Do not hold spin_lock while waiting in set_ios - - - --- 2011-01-27 Philip Rakity New
sdhci: Add support PXA168, PXA910, and MMP2 controllers - - - --- 2011-01-21 Philip Rakity New
sdhci: add support for hardware clock gating - - - --- 2011-01-21 Philip Rakity New
sdhci: support hardware clock gating in the SD layer - - - --- 2011-01-21 Philip Rakity New
] mmc: add support for H/W clock gating of SD controller - - - --- 2011-01-21 Philip Rakity New
sdhci-pxa: add support for reset_exit callback - - - --- 2011-01-21 Philip Rakity New
mmc: sdhci: Support for SD/MMC Dual Data Rate - - - --- 2011-01-21 Philip Rakity New
sdhci: add ops to force delay in operations due to silicon issues - - - --- 2011-01-21 Philip Rakity New
sdhci: enable CAP support for SD/eMMC/Wifi cards that are marked permanent - - - --- 2011-01-21 Philip Rakity New
sdhci: support setting f_max clock via call back - - - --- 2011-01-21 Philip Rakity New
sdhci: add host->ops to configure f_max - - - --- 2011-01-21 Philip Rakity New
sdhci: Add pre and post reset processing for chip specific reset - - - --- 2011-01-21 Philip Rakity New
sdhci: Enable BUS WIDTH testing for MMC/eMMC cards - - - --- 2011-01-21 Philip Rakity New
sdhci: remove support for quirks in sdhci-pxa.c -- not used - - - --- 2011-01-21 Philip Rakity New
sdhci: ensure clocks are enabled on all SD controllers - - - --- 2011-01-21 Philip Rakity New
sdhci: delete clk gating code and FLAG since not correct - - - --- 2011-01-21 Philip Rakity New
[3/3] sdhci: add support for DDR to platform code - - - --- 2011-01-21 Philip Rakity New
Subject: [PATCH 2/3] sdhci: Support for SD/MMC Dual Data Rate - - - --- 2011-01-21 Philip Rakity New
Subject: [PATCH 1/3] sdhci: register defs for sd 3.0 HOST CONTROL 2 - - - --- 2011-01-21 Philip Rakity New
A MMC card transfer issue - - - --- 2011-01-19 Philip Rakity New
[RFC] sdhci: allow mdelay to reschedule by not holding spin_lock - - - --- 2011-01-04 Philip Rakity New
[V3,2/2] sdhci: Support for SD/MMC Dual Data Rate - - - --- 2011-01-02 Philip Rakity New
« 1 2 »